I’m a bit suspicious now…is this your own install? however I would contact the installer and sort out if required as you seem to be on the...
Those multiplexers are fine for the job as I have used them a lot on jobs and are from the same suppliers as the cameras.
Put the system into walk test and trigger each zone to see.
Put the panel in installing mode and this deactivates all tampers.
Remove the +12v on the panel PCB(this will cover down the PIR's).
Once you have...
I use all Orisec equipment for installs.
Can’t fault their equipment and sales/support.
I install all HIK and for the money its very good kit.
We are currently installing a lot of NVRS with colorvu cameras(5MP) and I can say the...
Have you down powered the panel and back on?
If that fails I would try a full default and see.
Mark up all devices with zone numbers so when you reinstall you just need to change the device location name.
As Sparky says the battery will fit as it’s the same case.
Another point when you down power the system the external bell should sound?
The excel will direct replace.
The transformer powers up the panel itself.
Unfortunately due to having the 16 year old battery in for so long it’s damaged the board.
If you like...
Battery circuit has gone......you should be getting 12.5v upwards on the leads.
Just double check the battery fuse again and if ok then you...
Check what voltage you get from the battery lead.......low then new panel!
Changed the wrong fuse?
You can get rapid fit rj45 connectors.
Yes its fine to do that on 1.5 flex.
Surface contact will fit with minimal cable showing........ remember think twice......drill once
I would also check the battery charging circuit hasn’t blown.
Remove mains to see if the battery holds the alarm.
20mm drill hole for cable entry from soffit and use screws provided with camera to install
The orisec bell range has bright LED’s that can be seen clearly during the day.
Separate names with a comma.