I really need help with this. My bread machine was not heating up so i decided to check up the element, fuse, thermistor with a...
It is indeed divided there is 3 pipes linked to this gate valve one going to the loft the other 2 going down
1 is plastic 15 mmm the other 22mm...
what for??? I do not intend to replace with lever just replace gate valve furthermore I think you can use a bung to stop cold water tank no?
hwct hot water cylinder tank
I replaced the gate valve sitting on the top of the HWCT. To do that I shut the cold feed outlet from the CWT however when I close The gate valve...
very good post to make sure that the water coming out of the cold water tank is shut properly in the loft I want to run the cold tap in the bath...
sounds more likely it is the cause what sort of insulation material is required and can a builder do it?
OK thanks to all the replies
do you think that is the reason any other clues?
I had it checked up there about 2 years ago and he did a bit of flaunching somewhere up there
can a builder do it or do I have to call a specialist?
could be a metal plate inside the cowl connecting with the flue loose?
what can i do to prevent it?
It just started doing it!!!
I have a back boiler BAXI BERMUDA 50/4 during the winds I cannot sleep making a rattling metal noise coming from the chimney stack I guess it is...
everyone I know busy until next friday will have to wait till then.
My back boiler is starting playing up. It takes about 20 mins for it to ignite "start up" and makes like a small explusion seems like a...
CHECKED THE BATTERIES WITH MULIMETER ONE WAS VERY LOW REPLACED BOTH AND STAT BACK TO WORK. THANKS FOR HELP.
thanks for advise will try tonight.
you think the batteries but the lcd display does not show low batteries?
Since a couple of days my thermostat started to play up come home and felt really hot I though my wife raised the temperature checked it was on...
thanks guys but decided to go for Dulux safe bet. to cold to paint outside now anyway. by I will I will have saved enough :lol:
to be honest with you the rad is cold on the top left part where the bleeding screw is located.
am not to sure about inhibitor but I presume...
Separate names with a comma.