Started now and thinking of turning the stones into the ground, leveling, put a whacker plate over it then laying a membrane then the bark....
Not got my heart set on it, just thought if it could be used it would save tipping it then buying similar and seen it used in some B&Q video,...
Use chrome plated copper to your towel rail next time.
Very good job mate, should be proud of that!
I'm preparing to lay bark chippings in a 60m2 area of the garden that i'm converting into a play area for the kids.
At the moment there's about...
Open vent needs to be between the boiler and the pump so dont move it
Manual air bleed might sort it out
Everytime ive tried that place i cant get him
Its ok, i can smell him a mile off as i dont do ESTIMATES i do quotations
Fitted the dunsley before and ones with slumber circuits etc
Architect closed until monday and client abroad
Had the plans when i got home...
Got a new build to quote for, had the plans today anyone shed some light on what this may be??
Does it mean solid fuel with Dunsley etc??
All sorted now, thanks for the help i dont know the BG way so thought id ask
Not normally as its not subject to freezing like the ones in the ground floor, dont think youll find many installers that do
Veisman vitadens, megaflo unvented cylinder, unipipe ufh ground floor, stelrad compacts 1st floor, honeywell zone valves and programmable wireless...
My mate posted this on a forum i go on, can you help if hes covered or not please??
Thanks in advance
my bird thought she could smell gas...
About 2.5 lift and 6m length
No dont think so, when i spoke to Worcester on the phone they didnt mention it
Ta just had an email very similar to this, do i leave the isolation valve installed before the tigerloop whilst its priming??
You can get ellis board from plumb center for about a teener, that any good?
Local plumbers merchants?
Was a new coil fitted with the pump?
By pass screws in the return port on the oil pump
Pipe was sized for us at 10mm OD
All flared fittings and ok, only a couple at valves
Never had to fit one before and having massive trouble getting the air up to the burner.
Tried backfilling with no luck
Tried an oil suction...
Separate names with a comma.