Search results

  1. B

    Can Cadent Put A gas Pipe On Top Of A Path?

    Hi, Cadent have decided to replace the gas mains in the whole road and install new meters on the front of all the properties. The old meter is/was at the rear of the property next to the boiler inside. They have run a copper pipe to the front of the house which is pretty ugly but I don't think...
  2. B

    How Can I Check If I A Lintel Above The Window? (Updated Pics 20/11/15)

    Hi, I want to change my 4 ft kitchen window as it's old and the double glazing has blown. Its a wooden frame with aluminum and a 10 mill gap in the glass. The house was built in 1971. The brickwork above the window looks like it might sit on the frame but I am not sure. The brick course is...
  3. B

    Ferroli Falcon2/Modena water goes cold if heating is set

    Hi, We have a problem with the water going in hot and cold cycles to the shower and taps, running for about 60 seconds then the flame cutting out and restarting again about 10 seconds later. This is a long enough break for the water to run briefly cold in the shower and at the taps. When the...
  4. B

    Ferroli Falcon2/Modena water not hot enough

    I have a Ferroli 2 boiler which I think is also known as a Modena 80e. The problem is the hot water is not hot enough if the taps are run at what would be considered normal speed. If bath or shower taps are fully on for heat it will start running very hot then end up lukewarm. If I turn the taps...
  5. B

    Replacing old Honeywell room thermostat with terrier TRT1

    Hi, I have an old beige colour Honeywell room stat that is connected with the blue wire to terminal 1, brown wire to terminal 3 and there is also a green and yellow that is not connected. I want to replace this with a Terrier TRT1 What terminals on the Terrier do I need to connect the...
  6. B

    FER Falcon 2 Boiler Starts up and stops

    Hi, My boiler is a FER Falcon2 (GC NO 47-267-24) The hot water part of the boiler works fine and I get consistant hot water all the time. The heating part is the problem. When the boiler fires up it generally makes a "thawump" sound when it starts up. Almost like its pushing the metal...
  7. B

    Help with ceiling wiring after plaster moulding fell down.

    Hi, I wonder if any one can help me please. I was trying to carefully remove the ugly plaster ceiling moulding so i could take off the old light and replace with a new one, but after 2 hits with the bolster and hammer the whole thing came down.....with the light. The wires I have are...
  8. B

    Moving 1 light switch out of 3 gang light switch (with pic)

    Hi, I hope you can help me. My 3 gang switch operates 2 lights in the living room ( 1 way switching) and a landing light (2 way switching). I am putting in a new wall so I need to move the switch that control the "lounge" as in the picture to the new wall and use a single dimmer switch...
Top