Search results

When I said you need to power cycle. This means you need to remove all power and discount battery, then re apply power. This something helps restore functions that are not responding.

If panel not responding then power cycle panel. Total power restore may help!.

Engineer code can't be same as master/ user code.

Yes that's correct.

Did your previous detector have selectable resistor values. Have you a pic of old sensor.

Your pir requires resistors. 2.2k and 4.7k ,that's why you have a tamper fault.

Google resistor colours ? for what value you are looking for.

Have you put the battery in the correct way round? Always use a good quality battery brand. NOT cheap and cheerful. Would suggest you change all batteries in all devices at the same time.

Read10 April 2020 for instructions on how to reboot.

Garden room sensor tamper would suggest that the fault is on the movement sensor. I attach a post of the the spring to show you what you need to adjust. Control panel may have engineer tamper reset enabled.

Take cover off sensor, adjust spring by pulling spring gently to adjust. Put cover back on a d reset alarm with code.

Tamper spring may require adjustment .

Tamper fault on Garden Room sensor. Post photo of device in that room. Are devices all hardwired or do you have any wireless sensors ?

Check your deeds. Some have a covenant to prevent caravans being store on the front of the property.

Entering correct engineer code will access menu. Have you got that code number?

5 amp 12v encapsulated psu should be fine.

2.1mm is the most common.

No video would suggest cable fault or psu failure.