Search results

Thanks guys, there is an earth bonding - it just wasn't in the original photo. Will they charge me to change the bracket/fit the adapter or should it be free? Do I call Transco or the supplier e.g. Scottish Power? Cheers

thanks for all the replies! Made me laugh this morning - there is obviously some conflicting thoughts... I take it from the comments there is a white plastic clip I can get to fix the pipe to the wall bracket but having said that, the meter is supported by the pipe so no major issue. Hope...

Hi, I was just looking at my gas meter and noticed the right hand side appears to be hanging loose. Can you tell me:- - is anything wrong with this picture? - what is needed to correct it (if not correct already) - whose responsibility is it? (mine?) A few months ago I had a new...

Hi all, My mum's 1910 house has a single story kitchen at the rear. A few months ago, due damp smells in cupboards she had a builder inject a damp course into the wall (9" wall without cavity). Since then, the paint has flaked off BELOW the DPC - see photo. It seems to be getting worse...

Hi all, QQ - just wondering what others do when wiring up a Megaflo wiring centre, do you wire the Neutrals to the 3 x dedicated connector blocks below the strip or do you wire into the strip as per the wiring diagrams (ie 5, 6, 7 and 8 in Megaflow manual) Cheers

Thanks for the response. I believe the system is configured as S-Plan Plus (I have 3 motorised valves for HW, CH and underfloor heating). I checked with Worster Bosch this morning and they said I should still have a separate bypass valve fitted, is this correct? If so I'll get on to my...

Hi, quick question... I have just had a new Worcester Bosch 30CDi System boiler and Megaflo Eco 210i installed in my loft (by a local G3 installer). I don't know much about these systems but am doing a lot of reading up to get familiar with how it all works. So my question is, should...

nothing else giving off moisture - I have emptied both sheds completely for the time being. I was thinking about give the whole base (in and out) another coat of concrete sealer (from Wickes) and then giving it a paint with some garage paint on the inside. This should seal off the inside, I...

unfortunetely it's a metal shed without a base, the frame is bolted down to the concrete base. The base has sand, cement, balast for most of the depth (about 4" approx) and the remaining approx 2" is sand/cement/water. I think the problem is the top layer of sand/cement is absorbing the...

Hi all, Hope I have this in the correct forum.....I have water entering my sheds through the concrete and causing condensation. I have a concrete base in my garden with 2 x 10'x8' metal sheds on. The base is approx 14' x 22' with the sheds at each end facing each other. I have sealed...

Hi, Just wondered what a typical flow rate would be with a 1.5 bar twin pump? What would you expect from the pipes? Shower hose? and shower head? to be satisfactory? I think I was getting about 9 litres per minute direct from the pipes which I think is very low? (22mm pipes reduced to...

Yes, making all the right noises as soon as I turn the shower on - doesn't seem as if any air is drawn in. (I checked this by putting my thumb over the vent pipe and also but turning the shower onto cold only (which doesn't have a vent pipe). I'm starting to wonder if a 1.5 bar pump is as...

Sorry, try this.. http://www.kludi.com/uk/produkte-brausen-zenta.php

Hi all, I'm just about finished doing up my bathroom and have fitted a new wall mounted shower bar and a pump under the bath. Pump = Stuart Turner Showermate 1.5 bar Twin Pump Shower = Kludi Zenta (http://www.kludi.com/uk/remprodukt.php?lang=uk) Now, the shower requires 1 bar upwards to...

Just seen this stuff :- http://www.screwfix.com/prods/79333/Sealants-Adhesives/Building-Maintenance/Kitchen-Bathroom/Dunlop-Shower-Waterproofing-Kit I've already used aquaboard around the bath but could I have used this stuff on standard plasterboard instead? Or is it worth using it on other...