Search results

  1. R

    Vokera Condexa Pro - intermittant fault - under warranty

    Has anyone got any experience with the Vokera Condexa Pro light commercial boiler? A customer has two 50kw units with a master and slave unit. The right hand unit keeps going off on fault code A01 every 3-4 days. (this is 5 failed ignition attempts.) It appears that the unit is unable to...
  2. R

    firebird c26 combi enviromax model

    The customer is concerned that the heating control knob is not functioning on his firebird c26 combi. The settings are between 60 and 80 degrees. He says it is not possible to adjust the temperature. His convinced that the pcb requires replacing. Has anyone experienced a similar problem...
  3. R

    intermittant burner lockout on trianco eurostar combi

    trianco eurostar combi with reillo G5 burner. balanced flue. There is a built in twin channel time clock. The boiler runs fine sometimes, but it locks out other times. To get it to refire from lockout you can turn time clock from off to auto to run a few times and then it lights. When...
  4. R

    Firebird C26 - intermittant firing

    Hi there, Firebird enviromax combi c26. Reillo RDB burner When boiler is switched on green light for hot water lights up on front panel. The dhw pump switches on, so does the burner fan. The heat bank is not up to temperature but the burner does not fire. The pump, & burner fan...
  5. R

    hamworthy gas fired water heater - temp control thermostat

    gas fired hamworthy water heater - automatic ignition went to look at above water heater problems with water temp. noticed that the phial or bulb connected to the temperature thermostat had snapped off. all that was in the pocket was the copper wire, which then goes back to control...
  6. R

    Danesmoor 26/32 oil boiler lockout problems

    Lockout problem with a Danesmoor 26/32 boiler. Electro Oil 11d burner with satronic control box.T830b The burner has had a new nozzle and photocell replaced. Boiler fires, with flame then goes off. When the control box is reset the process to lockout takes 30 seconds every time. Was...
  7. R

    heating coming on when hot water only selected

    Fully pumped central heating system with 3 port danfoss valve. When hot water only selected radiators coming on also. ab, b and a pipework ports are hot. Motor recently replaced. The lever does not seem to go all the way to the hot water position on the valve. Would it benefit the system...
Top