Search results

no power light coming on. have checked fuse in plug and power to wall socket, both ok

to get the correct " working " pressure the boiler must be switched on. if it is as low as 6mb then it should be switched off and a warning label attached

Looking at printout, I'd say they never put it into service mode to test high and low settings should be 9.7% and 9.1% Printout signed Steve & Matt Should be Stan & Ollie

Set your multimeter to ohms. disconnect the wires at boiler, connect between two in turn and switch the thermostat on and off to find the two that make contact, connect them to 3/4 and the remaining one to 5 ( neutral ) job done

Hi Ian, just noticed a Ianjmcd based in Paisley on a cycle forum, is that you

We have water marks on hall ceiling after leak in roof. what is best to seal the ceiling before emulsion or is it best just to let it dry fully then a few coats of emulsion

Fit a radiator valve onto the tail tighten fully then keep tightening and the whole lot will come out "Simples"

Remove the cover from your changer. at the side of the CD cassette there is a small lever, press it with a pencil and the cassette should up out

I have am MG with a cd changer fitted, recently stopped working error cade, no disc and cassette wont eject when button pressed. Any help

Looks like your auto air vent bottle is leaking too. Best to get a small wire brush and clean the crud off the whole area and watch where actual leak is coming from before you start attacking it.

Where you bases in Ayrshire. I'm in thre stage of calming down work wise so might be able to pass you some jobs

Remove one black wire from clock switch, insert one wire from stat relay into terminal where you removed wire from clock. The two other wires, ( the one you removed from clock and the second one from stat) join them and fit them both into spare terminal. That way you have the clock and the stat...

Check the mode selector on the boiler. It could be set low tempreture on c/h put it up to at least 60 degrees. if this is ok check time clock or roomstat

Braided pipe connecting expansion vessel to boiler blocked. Disconnect pipe and clear. good luck, drain boiler and release pressure from ex vessel before disconnecting pipe or you will get a mud bath

if it's not sludge the radiators need balanced

The BG guy was out yesterday and replaced the HW thermistor and now I have flowing hot water. The old unit was black at the end instead of showing the copper element. 20/80 flowmatic does not have a thermistor. It has a hot water thermostat. As for the temp guage not available, i beg to...

Bet he says it needs a modureg coil as it's the only part not available

Just goes to show, not all engineers are created equal. Read more: //www.diynot.com/forums/plumbing/combustion-performance-test-ratio-above-0004-ratio.330999/#ixzz21L3qaRJv It's hard to soar with an Eagle when you are surrounded with Turkeys

Forget serial no. On data badge look for the gc no. if it's 4709416 you need part 7140. If it's 4709417 you need 8036 Hope this helps

Read through all the threads for this and noticed something that no one considered. Some modern wall coverings and paints react to heat and sould not be used near heat. I am not praising these fires, but how many times have you seen black staining above radiators. Again how many time have you...