Search results

Have ordered a full unit. Will try changing the powerhead firstly and see how that goes. Many thanks

Will changing powerhead sort this or would the whole valve need replacing?

Is it the motor that goes faulty? I see the motors are easily available on amazon, seems simple install as replacing the valve will need the system to be drained.

It is a honeywell v4043h1056 I have two. Another which controls a pool heat exchange. On that one I can feel the spring load when I pull back on the little lever. On the CH valvle this little level has no resistance at all.

Hive is set to off, the controller next to the boiler is also not receiving any commands to tell the boiler to heat up the radiators. Radiators are boiling hot. On the boiler the heating symbol is on permanent with the flame sign. Usually the anti frost will kick in during the night (boiler...

Both are primed and undercoated from factory. Under coat finish is white. Finish I am planning to do is eggshell black (water based). Would I need to do a grey undercoat before I paint black? I have a can of Johnson primer/undercoat in grey. Can I use this over the existing undercoat? Or...

I have been told that the horizontal flue for this model has been discontinued. Any one know if another part number would work for this boiler? GC number is 47-044-29

Thanks. Was looking at GGL MK04 2070 Centre pivot Pine Construction White painted internal Standard glazing What about Construction Pine v Polyurethane ? External finish White painted v Polyurethane ?

Any preference on where to purchase online? 780x980 Require two Centre pivot Thanks

My original post detailed me having the service void within the space of the rafters. That was before understanding I would need a VCL under the rafters.

Even though its only 2"' I don't want to lose any more height off the ceiling.

Would it be possible to allow for more slack in the VCL around the spotlight areas? This would prevent it from being disturbed during the installation of the spotlights. If I secure the VCL tightly against the rafters, I'll need to cut into it when installing the lights.

Emailed celotex earlier and they confirmed leaving 50mm gap between insualtion and plasterboard is not an issue. They did point out i need the VCL . So..   220 Rafters 50mm air gap (below the roof membrane) - 120mm rigid board insulation - 50mm gap/service void - VCL over the rafters -...

Are you referring to insulated plasterboard to address cold bridging? I spoke with my building officer regarding this matter. Since the rafters are quite substantial at 220mm, he has agreed that if I increase the insulation in between the rafters from 100mm to 120mm, I can then install standard...

Inquiry about completing a newly constructed cathedral/vaulted roof. Rafters with a depth of 220mm My current plan consists of the following: - 50mm air gap (below the roof membrane) - 120mm rigid board insulation - 50mm gap/service void - Plasterboard - Skim coat Questions: *Is it...

Banister, spindles not been fitted yet.

TBH i just want it shorter for the time being so i can easily move my furniture down. Thinking about it, for future, it may be an idea to have it removable - if possible?!

I recently had some stairs fitted. The newel post is at the bottom as the stairs turn into the room. Having trouble getting furniture down into the room, would be so much easier without the post in the way. Is it a simple case of cutting the post square? To replace, drill out a 50mm hole and...

Vailiant Eco boiler which is in garage. Usually when the weather drops thr anti freeze setting kicks in and keeps the radiators hot. Weather is not cold atm however the radiators are warm. Hive is switched to off. Hot water is coming from the taps as normal. Any suggestions what the issue...

I agree. Hence why asking which reputable brands and online stores to purchase from.