Search results

  1. B

    Potugease Sandstone Fireplace Stain

    Hi all, I seek your knowledge and guidance. I am carrying out a substantial refurbishment to my house. As part of the refurb i installed a Poruguease Sandstone fireplace. I was prestty chuffed with my efforts too. As i had other stuff to do I covered the fireplace with a dust sheet and...
  2. B

    Kitchen Larder Cabinets not Plumb with wall

    Hi all, Apologies if I am not in the right section, please advise if not. I am fitting a kitchen and the first problem I have encountered is not unusual but is causing me some grief. I have quite a few base units some standard height some tall (Larder, integrated Fridge, freezer and cooker)...
  3. B

    Self Leveling Floor products sourcing problems

    Hi All, Task. I am self levelling a concrete floor with no DPM. There is a discrepancy of 40mm over 50% of 9m squared floor. Once the floor has been levelled it will receive a micro bore, low profile, wet under floor heating system. I want to lay a liquid DPM, prime, use deep fill sell...
  4. B

    Bathroom extractor fan and three pole isolatore switch no earth!

    Hi all, I have purchased a bathroom extractor fan and there is no terminal for an earth wire. It is an Xpelair DX100HTS. I also have purchased a LAP 3 poles isolator switch which also does not have an earth terminal. I have wired in the fan from the lighting circuit through the isolator...
  5. B

    Install a bathroom cabinet with light and shaver socket

    Good morning all, I would like to install a Bathroom cabinet that has a shaver socket and light from scratch. I am quite comfortable with IEEE Bathroom Zones. I would like any relevant advice regarding this task but specifically the supply (ring main or lighting circuit?) and do I need an...
  6. B

    Up to Date Answer on Self Levelling Compound Over Bitumen Residue

    Hi all, Sorry to be a pain but I am pretty confused. I have lifted and mahogany parquet floor and found that the block adhesive used was bitumen. What I am left with is a concrete floor with a bitumen residue that I would like to self level in preparation for low profile under floor heating...
  7. B

    Initial Install of a Honeywell HT6360B Room Thermostat

    I have a Potterton Promax 24/2 HE Plus boiler GC No 41-601-17. A hot water Cylinder + Emersion heater and Cylinder thermostat Pump – Multi Head G Pt No 59506180 Valve 1 - Sunvic SZ2301 Valve 2 – Drayton Zone Valve Actuator ZA5 Honeywell ST699 Programmer A connector board...
Top