Search results

Thanks, I think this will work.

I was going to have a look at all the wiring.

Yes, the wire runs down from the ceiling in to the double socket as you can see then runs down to a socket below for the washing machine.

I have read the guidelines and I thought they can run vertical or horizontal so would still be classed as in zones?

We have altered our utility room slightly and moved the sink into the middle. I now need to move one socket over to the left side underneath the boiler. Problem is I can't drop the wires down vertically from above as the boiler is in the way. In the photo you can see where the socket is and I...

I plan to replace my Potterton Netaheat boiler vented system. It is for a 4 bed house and was wondering what boilers do you recommend as a replacement.

All done now.

Best way is to move the air separator up a little to give me the extra space I need on the pipe above the pump. As by moving the pump down it is still going to be to tight.

Oh, I see what you mean now. It should not be upside down. It has been like that since we bought the house in 2010. It has worked ok. It occasionally sticks when the central heating has not been used in along time.

What do you mean comment on the 3 port valve?

I did see on a diagram you can mount the filter either before the pump or after. So you saying I should lower the pump aswell to add more room for the filter connections.

Trying to find the best place to place my filter. I cannot do it by the boiler as the pipes run straight into the ceiling. It is an open vented system with hot water tank. In the airing cupboard I can mount it after the valve on the central heating side. This does mean that the water will only...

Pipe work in airing cupboard

Pipes

Just to let you know, i decided to strip the pump down and replace the seals, as at the end of the day it is only a seal that is worn out which would happen on any pump eventually. The shaft was not damaged and there was no marks on the shaft. Managed to source the seals for the pump for...

It is either replace 2 seals from a kit for £38 or spend £300 on a new pump. Would rather give the seals a go first!!

I have the following pump http://www.ebay.co.uk/itm/320907005314?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1438.l2648#ht_600wt_1185 It is the same as the one on ebay. It has a slight leak from the shaft seal on both sides. Can i buy a Stuart Turner Seal kit as below...

Thanks for your help!!! :D :D

I bought the following Water connection for shower 1/2" male to 1/2" inch male. It has an allen key hole on the back, I was going to have it mounted into the wall off the shower valve and i was going to connect it using a copper tap connector like the one below. The problem i have is...

I am installing a warix flange to the top of the hot water cylinder and the outlet to the hot water is 28mm. On the warix flange the outlet to the hot water pipe is only 22mm. Is it ok to run the outlet to the hot water 22mm from the top of the tank then up size to 28mm, as the pipe that runs...