Er yes ....
Has it been programmed in FROM ENGINEER MODE ?
Do what most of us do ....model number ....google ....installation manual ...it’s probably on a cloud connection so more than likely, settings ,...
One other thing ....this device you activated ...what area/ areas is it set for ? How are you setting the part sets ? Is it omit in part 1/2/3 or...
Version 3.1 on the wireless needed to have keypad yours is 2.1.4
Have you changed any setting via wintex ? As there a few non standard ticks e.g....
Look on wintex , at keypad ....post screen shot of keypad 1 on wintex
Magnets can get weaker as time goes on ...
1 it should ( check keypad tones )
3 probably not as the internal wireless part will be old ( check green sticker on wireless part )
I would try it first with some tape / blutak and see if it clears , if so refix it lower down
Apart from the magnet looking a bit high ....take the magnet off and hold it about 10mm lower at the side of the contact then move it away does...
Open the large 8x8 metal box
Has the battery been replaced ? Is the magnet in the correct position/ is it a internal type contact or a contact wired to the transmitter ? Post...
Don’t really have a problem , what make is your Cctv ? Analog or ip ?
Yes internal warning if set to grade 2 ungraded setting no
First job , Replace battery ...take old one out ....go to screwfix etc ....get replacement .
Do you have engineer code ?
No the bell won’t ring if it’s being blocked
No they normally fail and it’s not a speaker it’s a small piezo unit
Separate names with a comma.