It’s fine but keep it under 27. You shouldn’t need to go over 23 I’d say anyway.
Make sure a good high temp adhesive is used by the fitter. I...
Get SP101 plywood. Best plywood out there for flooring.
Use 6mm or 9mm plywood. A lot stronger then hardboard.
It’s magnesite. Remove it and get the floor asphalted or latex screed with a liquid dpm.
Yes mate. On laminate you will fine leaving 1mm gap per meter.
So a 2m x 2m Room you could leave 2mm all all sides.
Never seen tape used on cracks before.
Going back to the 1st coat. Which pro level was it he used?
How long between that and the 2nd coat. You...
Even with Quickstep Impressive lamainte you could leave a 3mm gap each side and seal up.
Get him to tile to the floor and with vinyl click leave a 3mm gap and Quickstep kit ( like silicone ) it.
Or leave small gap at bottom of the...
The sand and cement screed should be level to SR3 and solid.
Then if needed a coat of smoothing compound with the correct primer.
Then if another...
Yes mate that’s the only way.
If you want to take a section up. Say a few inches and send me a pic I can have a look.
If he’s put UfH on when the latex was drying that would crack it as rapid drying.
Is it loose when you tap it. Try get a knife under the crack...
Was that a water mix screeding compound? ( bag only )
Looks like it to me , or a latex ( bag & bottle ) which he has added water too.
All depends how far you want to go.
But best way is to take them up then Apply a coat of ardex NA , then some Ardex DPM1c to whole area.
Both Cheap LVTs with no bevel. Camero has the better wear layer of the 2.
Buy a floor primer like Fball P131 , Ardex P51 , Uzin PE360 , Laybond universal primer.
What are you trying to do ?
Will be fine mate. Give it a good scrape though so flat.
Look at the Quickstep Incizo Trim
If you want same level you will need to put some smoothing compound down in hallway. Or use a door trim in doorway.
You have to use beading around it or use hydro seal by quickstep.
Separate names with a comma.