Search results

  1. bazdaman

    Could I possibly have a copy of the baxi pdfs, thanks [email protected]

    Could I possibly have a copy of the baxi pdfs, thanks [email protected]
  2. bazdaman

    Replacing hot water motorised Zone valve

    If open vented you can bung the system so you don't have to drain, if it's pressurised you won't have to drain
  3. bazdaman

    Carbon Monoxide Leak

    What boiler is in the property? A mm odern condensing boiler can rust very quickly, also did you have a gas safety check only recently or an annual service aswell?
  4. bazdaman

    Should I balk at the shower arrangement?

    What does it matter, you will have no choice in the set up they fit
  5. bazdaman

    Radiators slow to heat after drain and refil of systme

    Easy enough, isolate flow and return and crack the nut on the end of the return iso, the gauze is in there, check in the manual for detailed instructions and location
  6. bazdaman

    Radiators slow to heat after drain and refil of systme

    There is a gauze filter in the return isolation valve on the boiler
  7. bazdaman

    Radiators slow to heat after drain and refil of systme

    Ok bet you have dragged some crap through the return filter
  8. bazdaman

    Independent heating in an extension?

    Zone off your existing heating system so you can use your existing boiler
  9. bazdaman

    Glowworm 30cxi repressure leak

    Put a new filling loop on and charge vessel wolesley part no 440442 it's called a disconnector
  10. bazdaman

    Worcester 30CDi over-temperature

    I have registered boilers with Worcester as old as 8 years so I suggest you give them another call
  11. bazdaman

    Baxi Duotec Plate Heat exchanger.

    Blocked plate forces heat down flow pipe
  12. bazdaman

    Baxi Duotec Plate Heat exchanger.

    Does the temp display rise rapidly to 80c plus?
  13. bazdaman

    Expansion vessels on hot water cylinder. Are they designed to fail?

    What colour was then replacement vessel?
  14. bazdaman

    Plumb sure 15x10 internal reducer

    They are meant to split, when tightening you will feel them crack and go slightly loose, that's normal tighten them back up and your good.
  15. bazdaman

    Mixer tap seal/washer at base of spout - how to replace?

    I have seen a 180 turn and pull out one, didn't know they existed until it came off in frustration!
  16. bazdaman

    External waste runs to hopper

    Bravo for holding your hands up, most here would bullshit their way out of it, we can't know everything . Sick to death of know it all's on here that can do no wrong, making others poster wary of looking a fool or being shot down. Rant over!
  17. bazdaman

    Replacing an isolation valve complications

    The service valve unscrew itself from where you have the arrow when you overtighten the connection to fill valve,
  18. bazdaman

    Are all TRVs made equal? Are Wolseley any good?

    Leave trvs open in summer and every now and then turn off and on. The trvs he's fit are bi directional so can be fit on flow or return
Top