Search results

Only one supply and voltage there all day

Na my ones at home are always live

Hi there after wallpapering mums wall I took 2 storage heaters off and they had old illuminated switches in place. Using voltage pen I put terminal blocks on before papering and one was completely dead and isolated but the other was showing voltage on the pen. So one has had a blank plate on...

Like you say do I gamble on small area but does say vinyl tiles

Oh this stuff bonds ok mate I dropped it in 25mm deep and dried in 4 hours it’s got fibre reinforced In

In fact I thought I would just see if it said owt and says can go over vinyl tiles so think I answered my own question thanks pal

No nonsense pal upto 50mm I used it under cabinets to about an inch

Hi anyone done self levelling over glue down vinyl tiles. It’s on a concrete floor stuck down sound just need to level the corner of kitchen 2mx1,6m at 15mm thinking sbr primer then levelling

Thanks guys got this done today after help

Nice one pal, that is great news, so it’s as simple as wiring the 6mm flex onto a socket. I was fearing the worst and expecting to have to change the cable having spent a bit on it. The smaller length of cable in pic For hob was too thick for the hob so had to use the pre wired cable from the...

hi there, if I can is that all good then? Or would I need to swap the flex for 2.5mm cable

Socket from the dual ? Would the 6mm flex need changing ?

Hi there Just realised that my new 2.4kw oven has a plug attached. I had originally wired in a double cooker outlet with 6mm cable to the hob (6600w)on 32a breaker and ran the 6mm flex also to the tall housing and next job was to connect the wire to a terminal block on oven. Problem is now the...

Last bit to decide on cooker socket to be loosened and skimmed next

No not uncomfortable just wanting to know the best way. Having to work around obstacles and as the best way would of been to run new cable I’m trying to work out the next best way. Have kept any boxes accessible.

Should I use junction box x2 and connect at 90 degrees wire across joining 2 boxes or should I put one in middle and make join. 1 is better but bending cable at 90 degrees not easy. What you advise please

Do you see any problems ? Was not liking using 2 junction boxes above but it’s ready to go now

Hi there I need to move my cooker cable 300mm to right and have decided to go down this route as access above is difficult. Will this be ok for regs please see pic. 2x junction boxes accessible above the cupboards into cooker switch then outlet that will have inspection door in unit

Hi people Anyone have any experience of using brick slips on plasterboard using grip fill or grab adhesive thanks just for a fireplace internal

Ok mate I’ll look into it