Search results

Delete the device from pro control, on dvr/NVR go to config > network > platform access scan the qr code if anyone else has the main ‘sharing’ account it will ask you if you want to unbind it. Unbind it re add to your device. Sole access. Installers don’t normally keep access to customers...

Put your code in Screen displays active faults No to acknowledge the fault Then no again to tell system you don’t want to arm it. Screen should be back to normal after that

By default I is night set and the bottom button II is alarm status. So you need to check the settings if you’ve changed them

What rated fuse did you put in, 1A? Is it still intact or has that blown without you realising. New pir wired up correctly?

Measured AUX output voltage?

KX12DT-WE , dual tech sensor infra red and microwave

Completely depends on budget. personally fit a lot of pyronix equipment and texecom in larger installs. Just got to add up what you want the alarm to do, prox tags/wireless fobs, Wi-fi enabled, remote monitoring

Definitely upgrade, upgraded a customers old accenta panel today to a pyronix euro 46 and swapped out all the pir sensors really easy and straight forward

Engineers code > no until volume control > yes > adjust entry volumes for A entry which is your entry timer on a full set and A exit as above but exit timer

Do you have the engineers code?

Likewise. had fobs learnt on and tested fine, then a week or so later it’s gone completely dumb non operational

They do give fantastic colour images at night. I haven’t noticed any ghosting images or poor quality at night time on the camera. The LED light can be adjusted in brightness and the annoyance is completely based on positioning obviously if it’s looking towards a window then you may get some...

I’ll PM you some images of my colorvu I think they’re fantastic for the price of them. The LED can be set to automatic for lux levels or on a timer and the LED light brightness can be adjusted. we have one on our driveway permanent LED as a deterrent to protect the vehicles. The IR on the...

Bellbox might be knackered with any luck when you drop the power nothing will happen :whistle: like sparky said after 15minutes it should stop.

Cut it off and remake the end easy

You get what you pay for at the end of the day, if you’ve got the money for more 4mp then go for it. If not take the 2mp get them cabled and then just update them as and when you can

Hold Menu and Tick enter into on board menu then scroll through to power save mode and turn off. I’m not 100% sure but I don’t think this will cure your prox issue I believe pressing the tick activates the prox reader.