Search results

Post picture of the main panel inside the house

Correct, that is the fuse carrier for the panel

Engineer code > zone number ( I.e 02) > yes/enter > 00 Not used > enter > back to installer mode > 99 enter escape installer mode

Remove zone wiring and power to the sensor from aux 12v and 0v. Enter installer mode and disable zone in programming.

Level set - If ‘Yes’, the system becomes ‘level set’ (having one area set only at any one time). If ‘No’: The system becomes an ‘area’ system (fully independent areas).

private messaged

I’d guess your top 3 cores then the lone 12v + and -. Best bet would be to trace the O/P cores I labelled as bell that will lead you to the others for certain.

Bell will only sound for 15-20mins if the battery inside it is still healthy once the power to it is removed

Ignore the bell. Remove the zone cabling to the pirs you wish to re-route Remove the 12v 0v feed for them Re-route and put back as they were Exit engineers mode

TP Link power line adaptor

The end user would receive an instructed handover from the installer on the use of the system and application chosen it’s not a one app fits all so manufacturers can’t provide you with that

Private messaged you

YeeHawwwww!

Hikvision website has all user manuals pdf and firmwares if required https://www.hikvision.com/uk/products/

What alarm panel is it? These MCPs are 24v operation

Forgoing the conduit will save time just clip the cable round if you use the back entry on the junction boxes you can use the mortar line to take the cable into it

They have a row of dip switches on the back 1-4 I believe on those so if you have more than one keypad you address them as such.

No need to down power, remove the old keypad replace for new make sure they are addressed the same. Just avoid shorting the +12v and negative You will get an internal tamper alarm on removing the old keypad but you could just wire up the new keypad then enter engineers menu before continuing...

low battery in the wireless bell.

The 9943en will work with the Scantronic 9651 panel