Search results

It’s a window seat

Neither, 225mm solid block

So just because external wall getting wet might not be a problem? Patio falls away from house too even though ground level higher than should be?

Any suggestions? Other than taking out patio? And can’t change drips…. there was water repellant used in rendering. Any chance might be ok?

Maybe wrong forum should be in building?

the work top is 30mm thick, have I got enough room by adding those feet and adjusting doors I wonder to get past it… kit hen man coming tomorrow (wed) so wondered if could be done…or anything else. There is a gap above cornice on units….?

Thanks v much, where would I get 1cm feet for under fridge? Forgive my ignorance in these things!

yes it’s over 700 mm deep maybe 750ish

I don’t think it was designed that way, but worktop on counter won’t allow door to open fully….so that’s why we pulled it out a bit more

Hi below these rear windows I have noticed the wall/plinth getting wet during any heavy rain. I’ve noticed the drips on these windows are not very deep. The render had something out in it to keep water out (?) but should I be concerned about water getting through in the near future?

American fridge freezer doesn’t sit flush with new units as expected. But is this protruding too much. Kitchen designer was told make and model . Looks like countertop stopping moving it back. Is now sticking out by 12cm. Or do you think it looks ok?

yes good ideas, actually got an isolator switch for fan in a cupboard, lower down obvs

yes it does is on external wall

yes it is 1050 above hob, your suggestion makes sense too. Overall from yours and woodys comments doesn’t seem like it will be disastrous as it is? However I was thinking when I’m old and shrunk a bit it might too high for me to reach!

EC0684A7-D7CE-4B97-BC6D-C64CC0C7ECE0 by DC1977 posted 1 Apr 2022 at 10:33 AM This photo shows size of extractor compared to hob, it’s a 100cm wide range, 6 burners. This is the extractor ELIBLOC HT80 - 72cm...

Hi don’t know if this is correct place to post this but had lots of useful tips here before. I know there is min height from hob for extractor fans but ours has been installed at 1.05 m above hob so I’m concerned about it’s effectiveness ? Also we have built a massive kitchen diner and my...

a bespoke floorbox with trimless brass was £580! Other options cheaper but still £200

good idea, any problem with getting an elec cert? Not that we are selling our home anytime soon…