Have a look at Aquaplug, marvellous stuff.
Take the oportunity to replace it with regs size if its not 840 x 840mm if ok, my hearth is just two pieces of slate side by side.
Im afraid your not seeing as I do, its only the short section that needs the bottom scribing off by 20mm
Edit:Ah, I see its a room to the left and...
I did a small artex ceiling with it close to 30 years ago and its still there
Skirting on top level has 20mm cut off the bottom
Ive tried polycel smooth over which was ok for the job inhand
I think this was meant?
Are the rads an extension of the main house heating system?
Draw all round bolt wth soft lead pencil then wind it in and out a few times to see where its rubbed off
just this morning have done the same...
Unless the parking brake is on or its rod connected as it forms the drive belt tensioning mechanism.
I am basing most of my replies based on my...
I spent a lot of time removing paint so blocks could be rendered so wouldnt be putting any on as a temp measure
This is countax, anything look familiar?
When timber is referred to as “Chestntnut” it invariably means Sweet Chestnut which is high in tanning and very rot resistant. Horse chestnut by...
Are you saying the top crankshaft pulley doesn't turn?
If the end of the flexie has a compression fitting then one of these may be better, sharp end CF could cut through the sealing washer...
Thats one reason I asked for the pic of both tensioning pulleys John
Can you take another pic further left showing the two pulleys that move together ?
If everything was working before the belt went then you may...
As I thought, the levers on the right are deck height and pto for rear collector
are there any peddles on the right...
When you grip it keep part of the width of the grips below the bottom of the nut otherwise the pressure needed to get a grip will crush the...
Separate names with a comma.