Search results

I’ve got someone coming around on Wednesday but just wanted a heads up what it could be I’ve seen posts about faulty gas valve or fan so don’t mind paying if it’s just that because he’s talking of replacing boiler but it’s been fine for 15 years only ever had to solder dry joint on PCB before...

I have a Potterton neataheat 60e the pilot light comes on but main burner not firing up I can hear and see pilot ignitor clicking when pilot is already on but main burner not coming on any ideas please

Yes stripped it all down and give it a good clean still no joy

My aqualtis washing machine is leaking from the soap drawer and running out of bottom of door it's getting that bad I have to put towels down now, I have removed soap drawer and cleaned still no joy any ideas thanks

How do you wire up from receiver to boiler do you need a perm feed from receiver to boiler then how do u make it switch from receiver

We have a couple of brick pieces that have fallen off,on a outside wall, i want to protect it with some sort of paint or sealant any ideas?. I have heard you can use pvc glue and water is this true. Please help

forgot to say it is a double element, and reistance on both are ok, and both are not working.

Smeg oven top grill not working tested element reading ok, getting 240volts to element when switched on but no heat. On further inspection i noticed the small oven variable grill knob just spinning around and around, it should notch from 1 to 6 and stop. I took top panel of on cooker and found...

We have a Hotpoint Aquatis AQGD 169 S washing machine, and the plastic drum paddles inside the drum keep breaking off, we have had the machine about 18 months and no problems but i have changed 2 paddles in about 6 weeks. Is there a special way to fit them because there is a bit of metal in the...

Fitted new programer Potterton EP 2002 and all is fine, it was a straight swap, £32 of E-Bay. :lol:

We have a potterton ep2001 programmer and if you switch both CH and HW to off on panel it goes off like it should, then all of a sudden the LED's on CH and HW come on and boiler fires up, how can this be? Also when the controller should go off when set time both LED's stay on and boiler still...

It is called add on and you can get from any upvc suppliers ie Gap

We have a electrolux premier double oven, and when the main oven has been on for a while the fan stops working and the interior light goes out but the oven stays, on if you switch off for about 5 mins and switch back on again it is ok. Any ideas very frustrated wife nagging me!!!!

i will take a couple of pics tomorrow its at my mates house thanks for your help

could the catridge insert be causing the problem, or is it more likely the cold side

it has like a blue mesh attachment ,nothing like the cold side. i have not really studied it but should it have a washer same as the cold side

I have a mixer tap and it drips all the time, i have changed washer in cold tap but it still drips took apart hot tap but this is different, ie no washer. Is it the cold side or hot side causing problem? please help

no that is not the part, i have found the part i want but you have to buy the whole element because the 2 stats are attached to it. there must be somewhere i can just by the stat, please help

Found one of stats open circuit by passed it and the heat came back. Where can i buy a new stat it is a WHIRLPOOL AWZ121

found two stats at back of dryer when i test between the terminals should there be a low ohm reading on stat. also i have been reading about you can reset stats by pushing a button can't find a button to press on these two stats. tested across element this is ok