Search results

Good morning folks. I'm remodeling my bathroom and moving a basin to a different wall. I thought that everything was working out as I'm removing a bath and putting in a walk in shower, and the fall was more than sufficient for the extra run. I had planned to tee the basin into the shower...

My concrete sectional garage is leaning off the vertical by a good 50mm or 2 inches if you are old school. It's nearing the end of its life, but I'd like to tart it up to get another few years out of it as I have other plans for my funds before a new garage. Any ideas as to how or if it could...

Hi folks. I am fitting a bathroom in an existing attic conversion and would like a bit of advice regarding the soil and waste pipes. I have building warrant in place but the wastes are all just shown as schematic lines to a new stack. I have had a new inspection chamber fitted and will...

I am waiting on building approval for an attic bathroom in an existing conversion, but trying to get as much non structural stuff done while I wait. I have a question about the roof work which is holding me up badly just now. My architect has said that I need to double up the rafters each...

Hi folks I am removing my old boiler and because of other work I am doing i will not be having a new pressurised system fitted for around a month. My question is can I cap the feed and supply from the ch header tank, drain the CH system and carry on using the emmersion for hot water in the...

Hi all. I have been reading this forum for a number of months to help plan my kitchen diner refurb, but have arrived at an issue that i could not find an answer to. The following picture is of lagging on 15mm copper hot water pipes that was only on a small area once i removed the boxing...