Search results

Hi, the woodburner installer cut out a section of plasterboard and replaced it (im guessing with heat resistant plasterboard) behind the woodburner, the problem I have is even after filling, sanding and painting the join between the new section of plasterboard and old the heat makes the board...

I have recently moved into a house which has had a garden room extension added, I have just recently noticed that the roof tile edging is breaking down and falling into the gutter can anyone advise if this has been build wrong and how I can put it right??

Hi After removing a strangely located light socket I now have a gaping hole in the door architrave (see pics below) any suggestions on how I can repair this? Can I fill it in somehow or will I have to repplace the whole sections of architrave?

Hi Can anyone advise the best way to fill in around an oak lintel above a wood burning stove which has shrunk since installation and left cracks and gaps? the initial movement left a section of plaster attached to the top of the beam and then a crack between that bit of plaster and the...

Hi Could someone advise the easiest way of fixing the joint in the ceiling boards which seems to be coming loose? (see pics below) Andy

Hi I am considering repairing my timber windows which are double glazed but with a lead pattern on the outside of the glass. Most of the glass panels have condensation on the inside which I would presume means they are not now sealed and ineffective and also the strip of insulation seal...

Hi does anyone have any recommendations for bending a facia board to provide a finish to the decking I have built (picture in my album) the decking is raised about 200 mm from the path which curves round it and the decking is cut to match its curve, I now need to attached a facia type...

Hi does anyone have any recommendations for bending a facia board to provide a finish to the decking I have built (picture in my album) the decking is raised about 200 mm from the path which curves round it and the decking is cut to match its curve, I now need to attached a facia type...