Search results

  1. 8

    Vertical drop 50mm bath waste

    I'm hoping to relocate the bath from one side of the bathroom to the other. Unfortunately the joists run the wrong way to accommodate the drain. Is it allowable to route the drain from the bath down a 50mm pipe vertical drop to the kitchen and out through the wall? In the kitchen I would be...
  2. 8

    Bathroom rad always hot

    Hi, As per title, just updating the bathroom while I am spending the time at home. Since we moved in, I'd noticed the bathroom rad became hot whenever boiler demand was called. But hadn't really thought too much of it. Just traced the plumbing back and it runs between ch flow and hotwater...
  3. 8

    Over notched joist

    Just replacing the bathroom suite while I'm confined to home. However I've been confronted with quite a bodged previous install. I'm after some advice on the best way of reinforcing the over sized notch which has been done adjacent to the wall. Thanks
  4. 8

    Opinions roof above bay window

    Please see attached photos showing roof above bay window. My thought was to seal all the gaps up with silicon, then use celotex to insulate with expanding foam to hold it in position. Use some new damp proof membrane under that and finish with some new 12.5 plasterboard. My worry is would...
  5. 8

    x2 Single Pyrolytic Ovens on kitchen ring.

    I'm just about to have my kitchen refitted. I've had an electrician to come and have a look. He's quoted me £2500 for a rewire. We are after new lights and lots of fiddly bits around the new cupboards. The bit that worries me, is that we want to mount x2 pyrolytic neff ovens away from the...
  6. 8

    Condensation at top of internal soil pipe

    I'm after some advice. I have a property with 2 soil stacks; one on each side of the house. Both internal, they run straight from ground level up to the loft with the relevant connections. Once in the loft the 2 soil stacks are joined by a horizontal soil pipe laid across the ceiling joists...
  7. 8

    Wetroom drain ball joint

    Just fitted a shower drain in a wetroom floor former made by dallmer, it includes a ball joint for easy installation. Do you have to solvent weld the ball joint or is there a seal in it? Thanks
  8. 8

    Miele Dishwasher f11 drain fault

    Hi I've got a miele g5191 with a f11 drain fill fault. I've done some fault finding as follows. Run quick wash, the machine fills, washes. Appears to have 2 goes at draining then throws fault. I've then triggered the flood switch which operates the drain pump and drains the machine...
  9. 8

    Lintel inspection??

    A couple of weeks ago, I noticed some cracking in the outside brick wall of my house. This took the form of diagonal cracks through the mortar only above the lounge window and another vertical crack below the window. I phoned the insurance company who have then assigned a structural...
  10. 8

    New bathroom light.

    Hi, I've just bought a new bathroom light from b+q. Just had a look at the fittings, there's no room for any extra wires apart from the switched live and neutral. Which I'm guessing means using a junction box in the loft. The thing that's really got me baffled is that there are no...
  11. 8

    Upstairs solid (fibre) internal wall

    Hi, I'm after a little advice. I am in the process of replacing my bathroom suite. I've just removed bath, sink, toilet and the remaining tiles. On the removal of the last tiles I've found a large damp area on one of the internal walls, which I had assumed was a plasterboard stud wall...
  12. 8

    Internal French door and demi panel instalation

    Hi, wonder if anyone can give me some advice. I'm in the process of fitting some internal french doors with a demi panel at either end. These are pine doors/demi panels from wickes. I started with an opening between sitting room and dining room where I am now creating the room divider...
  13. 8

    Corgi cert required.

    I have recently had a gas hob installed in my kitchen. The fitter was supplied by the company and was supposed to be corgi registered. I have since asked for a corgi cert and have been furnished with a gas safety certificate for the hob. Although this bears no reference to the altered pipe...
  14. 8

    Kitchen ring main damged

    The ring main supplying the kitchen has got damaged. There's a bit more to the story, would any body be able to tell me whats required to repair it. See link. //www.diynot.com/forums/viewtopic.php?p=1005448#1005448 Thanks
  15. 8

    kitchen installation

    This isn't really diy......... as I'd hired in professional(?) fitters from a well known kitchen company. I have a couple of problems that I'd like information on if possible. 1) The fitters couldn't get the plumbing behind the dishwasher, so they knocked through the plasterboard and have...
Back
Top