Search results

  1. T

    Mystery pipe in garden

    Hi, removed an old shed and clearing the old base I unearthed this pipe. Looks like a drain valve but no idea what for or if it’s still in use. Anyone have any idea what it could be? cheers
  2. T

    Replacement for Baxi WM 40/4 PF

    Looks like my boiler has had it. Looking to get it replaced with something that can be sited in the same place. (On external wall under kitchen counter with rear flue) Does anyone know of a Heat Only boiler that fits the bill?
  3. T

    BAXI WM 40/4 PF - Water in APS Nozzle

    Hi folks, I have a Baxi WM 40/4 PF boiler that has served me well for many years (I think it was installed in 1989) Anyway, it has recently developed a fault where a small amount of water is collecting in one of the APS nozzles. As highlighted in the attached image, it is the nozzle...
  4. T

    Heating only comes on if Hot Water switched on first

    Hi folks, I have the above problem with my boiler and after reading through a lot of threads on here it sounded like the issue could be a faulty mid position valve actuator. So I bought a new one, fitted it, but the original problem persists. To give a bit more detail, if the HW is set to off...
  5. T

    Mains cable earth wire too short for new cooker control unit

    I tried to replace my cooker switch last night but the mains cable earth wire is 2 or 3 cm short. On the old one, the earth connection was on the middle of the plate, however on the new one it is on the far right. (cables come in left side of mounting box) Here's the link to the wiring...
  6. T

    Gas Hob & Boiler Problem

    Hi there, I am having two problems with Gas in my flat but I am not sure if they are related. It is a bit of a co-incidence that they both went wrong within a day of each other though. Firstly, I noticed on Monday night that the pressure on my gas hob increased. I would say at the max...
  7. T

    Tavistock Taps

    Hi there, does anyone here have experience of fitting Tavistock taps? I was thinking of using them for my bathroom sink. The reason being they are one of the few modern looking monobloc mixer taps I can find that claim to work on low pressure systems .
  8. T

    Increasing Hot Water Pressure

    Hi Guys, newbie here, I've had a trawl through previous posts but I can't find an answer to my problem. Basically, I am wondering what would be the best way way to increase the hot water pressure to my bathroom/en-suite and possibly kitchen? The water pressure is terrible in the bathroom...
Back
Top