Search results

Hi folks Our soil pipe is boxed in. It's horizontal and it's been leaking for a while now when the shower is used. I have cut out a section of the plasterboard to access it and it's leaking from where the shower waste pipe comes in. It's not leaking out of the white pipe but out of the section...

Looking to replace all of it . Thanks

Are these still available? Or is there a direct replacement for it. Thanks

Can anyone advise the best method for taking off about an inch from the top of a timber post already in place

Hi all. I have just replaced a mixer tap in my motorhome sink. The hole is just slightly bigger than the tap. Any idea where I can buy a base ring to conceal the hole and fit the tap on top? Needs to be flat & chrome. Thanks

So every ten mins or so the keypad emits a two tone beep. Green unset light is steady and system is unset. Any advice please

I'm about to fit some reveal trim around the patio doors but there is quite a gap that will be left when the horizontal trim is fitted above the door frame. The gap looks to big to fill with caulk/sealant What's the best options? Thanks

Apologies if this is a question that gets asked lots! I have replaced the kitchen tap with a new one. The braided hoses that come from the tap have the 15mm threaded nut with washer at the end. My hot and cold pipes have a small section of copper pipe with a nut and olive on the end. What...

I have a horizontal soil pipe which is boxed in. I have noticed the plasterboard is staining in three locations along the boxing. There are three waste pipes attached to the soil stack in similar locations to where the stains have appeared. Soil pipe was fitted about 5 years ago. From what I...

Hi In our house the soil stack runs horizontally in a boxed in section. The upstairs bathroom waste pipes are connected into this. I have noticed a small water leak patch on the plasterboard of the boxed in section. The soil pipe is is near impossible to access from the void (dormer roof) but I...

Have just wired up the bellbox as per manual using connections ABCDS like for like at both panel and bell box. system is clear but bell box isn't operating. Have taken cover off and tamper doesn't even come up On the panel the right side led is flashing on the bell box also

I have casement windows that I want to open fully outwards. They have standard on at the moment. I would like to open the windows fully out. is this possible?

Is this easy enough to do? Can these be purchased off the shelf?

I have just fitted some larch cladding and noticed some black spotting/mould appearing in places. Can anyone advise of a good product to remove it before I put a coat of oil on. thanks

Last piece to infil where the patio doors are and it's a piece that needs to be fitted tongue first. It's on 50mm wide but it keeps popping out. it will have a quadrant fitted over the gap between door and floor when finished. mess gonna hide the screw or nail under the quadrant any issues?

Hi is there a hinge that can replace the standard restrictor/hinge on a pvc window so the window can be opened back further

Looking for some small downlights to instal into soffits of a garden room. ideally no more than 50mm in diameter or cut out and finished in black. Prefer dimmable if possible. Any recommendations. thanks

I have a garden room which I’m in the process of building. I have decided to go down the cold roof design. I can achieve 50mm ventilation front to back of the building as the joists run in that direction however I have a side overhang which has been built by cantilever off the front to back...

I have an electrician booked in to connect a 6mm SWA cable from a dedicated 32amp RCD breaker in the house fuse board. The other end of the SWA is going to be connected into a rotary isolator for the hot tub. Can a new weatherproof double socket be spurred from the rotary isolator?

I have an electrician booked in to connect a 6mm SWA cable from a dedicated 32amp RCD breaker in the house fuse board. The other end of the SWA is going to be connected into a rotary isolator for the hot tub. Can a new weatherproof double socket be spurred from the rotary isolator?