Search results

  1. V

    Ferroli modena 102 venturi

    Hi, My Ferroli boiler has stopped igniting. On investigation one of the venturi on the tube from the air pressure switch had disintegrated, further investigation shows the other to be disintegrating also. iIhave searched for part number/ suppliers with no success. Any help would be...
  2. V

    Flow temperature on Greenstar junior

    Hi, I had a Worcester Bosch Greenstar Junior 24i installed 5/6 months back but the boiler has to be set to max to get enough heat around the house just now. I checked the temperature of the flow pipe from the boiler, at the boiler, and the highest it gets is 66/67 degrees. return is 10/11...
  3. V

    mira 915b

    Hi, I have just replaced the seals on my Mira shower. Unfortunately I didn't not note the position of the thermoscopic valve in that I don't know how far it was screwed into the body. Having re-assembled the cartridge the shower is not only giving a scalding temperature. I'm assuming this may...
  4. V

    Worcester Greenstar

    Hi, I am considering having the above boiler installed in a bedroom cupboard. The cupboard is large enough for the boiler and the required clearances and would leave ample space for shelving for airing or storage. However in the 'online ' manual the following is stated; "If fitting the...
  5. V

    rain marks on exterior wall

    Hi, my father in law lives in a second floor flat. His neighbour below has been complaining about water appearing on the interior window head. Her window is below but offset from FIL's window. I have checked his window and someone has filled in the underside of the wooden cill with mastic and...
  6. V

    Roof space ventilation

    Hi, I'm planning on installing a lean to door canopy above my front door. The length would be 1650mm and 500mm deep (approx). The roof would be clad with 12 Marley ludlow roof tiles on membrane paper on top of OSB. The underside will be clad in upvc shiplap cladding. Will it be necessary for...
  7. V

    lintel replacement

    Hi, I previously posted regarding spalled lintels in a No Fines concrete house. I engaged a structural engineer regarding replacement of these. However I would appreciate your advice as to the best way of building the replacements in. The SE has specified a replacement which is 210 in height...
  8. V

    spalled lintels

    Hi, I have a No Fines constructed house and both ground floor window lintels have spalled on the bottom edges. I reckon they could be repaired using epoxy but think it may be better to replace. The lintels are precast concrete ( with 2 fairly hefty twisted rebars) both 80 high x 180 deep and...
Back
Top