Search results

Hi guys, Are these bypass valves? there’s a small nut which unscrews which gives more access to the spindle cheers

hi guys & gals Im currently doing a bathroom refit and have noticed the stud wall is just 18mm x 47mm vertical pieces of osb(i think) i have not come across this before. the plan was to overboard with cement board or have new plasterboard then tile, taking into consideration weight per m2...

my bathroom is tiled in the shower cubicle and above basin the rest is painted plasterboard (dot and dab and stud walls) is it best to overboard with backerboard or plasterboaord or rip all existing out ?

Efl i dont know which is more dangerous the fact that its incorrectly labelled or the fact that if the socket breaker is off 4 live sockets still remain. but a spark has done it so must be ok?

well thats rubbish 1 room split between two breakers not labled correctly kitchen breaker isolates kitchen and 4 lounge sockets socket breaker isolates 2 in lounge,hall,and front room too much to ask to have kitchen sockets on kitchen ring only all others on sockets ring?

just had a rewire to bungalow Lounge has 6 sockets 4 of the 6 sockets are on the kitchen breaker at consumer unit At consumer unit there is two breakers relating to sockets Kitchen sockets Sockets Has this been wired incorrectly or is this just bad practise

hi guys Im not sure if my existing light switch wiring is correct there are two cables to the switch i am assuming one is from consumer unit the other is to the light the cable from the consumer unit has live and earth the cable to the light has live and earth and neutral not being used is...

hi guys, The mortar/concrete to the bottom of my house has cracked and come away in places, i have removed the problem areas but ensure on which trim to use should i use a bellcast only or should i use a plynth aswell so there is a break between upper and lower? existing was finished flush and...

EFL you say non is really required dont you think it would be better to isolate with remote switch for maintenance purposes/faults? 1 light pullcord/ceiling rose straight to fan 2 light pullcord/ceiling rose -3amp fcu -fan with remote 3 pole isolator (diagram) 3 light pullocord/ceiling rose...

thanks for your reply eric i was just unsure wheather to use a 3 pole fan isolated being 10amp or 3 amp fcu or both i.e if a problem occured with fan fuse blowing at 3amp would be better than mcb tripping at 6amp? wouldnt it be safer,i also wanted to install same as manufacturers instructions...

new pipework

new pipework

new pipework

blocked

hi guys I am changing my existing non timed extractor to a timed extractor xpelair vx100t 12w/230v=0.05 amps should i include a a 3amp FCU outside bathroom and a 3 pole fan isolator in loft near fan or will just just a 3 pole isolator be ok, if i put just a 3 pole fan isolator 10amp wouldnt...

There's no flies on you lot! Checked wiring in socket all wires were secure Checked with Socket Checker and no earth [/IMG] Changed faceplate sorted problem

thanks for the reply's i get 000.4 ohms

yes i have multimeter autorange what do i do

my neon screwdriver lights up on all conductive parts on dishwasher should this happen? or is it faulty cheers