Search results

Hi, I want to fit a shower pump alongside the HWS tank, but I have found that the top outlet fitting is a male 22mm compression fitting thread (22mm or 7/8" ??) although the coil unions are 1" females?!?!. Is there any way of adapting a conventional 1" or 3/4" thread Surrey/Warix flange...

I'm looking at doing the following... 1.5 Bar Salamander pump on floor at side of WHS tank... Warix flange from HWS tank and new drop from CWS tank... H+C pipes from pump outlet back up into loft ~1.5M... 4M pipe run over to en-suite... ~1M drop to mixer... Doing some rough pressure...

Hi, I am just about to replace the shower tray in my en-suite and will be relacing the old tray with legs for a stone cast one that sit flush to the floor boarding (chipboard). The existing drain runs above the floor and down through the floor next to the wall from where it runs parallel to the...