Search results

Hi Everyone I have house which was built in the late 70s, I always thought the roof was natural slate untill I googled why I was having massive moss problems. It turns out it is a Asbestos cement Slate(looks exactly like a slate) I am now looking to get the roof replaced due to state of the...

Hi everyone I am going to zone my house upstairs and am going to put a 28mm 2 port valve in. I have just knocked a hole in wall in the garage and found the return pipe from upstairs. Question is Will it matter if I put the valve on the return ? Or will I get heat leakage around my upstairs...

Has anyone used these pumps before and can tell me if they are any good?

Hi everyone. I am changing my taps on my bath from single pillar to a mixing shower type. Problem is the bath holes are 185 centre to centre and the single block wont fit correctly (180 cc) its over one side or the other too much. any thoughts ?

Hi I am looking for some pointers here, I drove the car home last week and it seemed lumpy when driving it. I got in the car the next day and the car would not start. The engine turns over but there is no Ignition. I have changed the spark plugs, but still it just wont fire. Any pointers to what...

Do I need planning permission to convert a attached garage to a room in northern Ireland ?

Ideal

I need to get a few actuators for a manifold but cant seem to find them anywhere has anyone come across PEXEP type 24 v actuator pexep nr 314250 push down and turn 45 degrees to fit on valve.

I need to get a few actuators for a manifold but cant seem to find them anywhere has anyone come across PEXEP type 24 v actuator pexep nr 314250 push down and turn 45 degrees to fit on valve.

Hi all Three years ago I installed a fan in my bathroom thin has a timer which runs on for 15mins , no problems with that but the fan was not powerful to remove the condensation from the room and I got a small patch of mould on my wall. So I brought a more powerful fan which pulls twice as...

When fitting a socket for a tv coax if the cable is straight through the wall can you fit a socket without a back box ?

got a old sump pump with a mercurry tilt switch on it where can you get pumps from for these ?

What size cable should be run to a immersion heater on a 15 amp fuse ?

what recommendations have people on pipe slices , I have a few but the wheels keep going back and not springing forward. I had a good 28 aluminium one with yellow on the side but lost that.

Hi everyone I have a load of copper end feed fittings which are dirty and covered in green and brown. Instead of cleaning each fitting has anyone got any suggestions to put them is a bucket of something to dip them to do a big clean ?

went to one of these today and the fan was running and running, pulled burner out and put a bit of card over end and she fired after 10 seconds. Put burner back in boiler and sometimes she fires and sometimes she does not. Changed the control box and photo cell and it sorted problem...

what is the tool called which holds the fan and had a screw which pushed the shaft from the motor from the fan ?

On a 3 phase motor which has a overload which had tripped could it have tripped due to the motor getting hot and drawing more current ? Went to job today where the overload had tripped and needed the button reset on the overload. Reset and the motor ran fine. This is the second time it has...

what size are the holes in a metal back box

how much heatloss as a percentage of your boiler will you get for insulated pipes uninsulated pipes