Search results

Does the motor on the 2 port valve continue to operate even when the valve is fully open and it can travel no further. I ask this because I have disassembled my 2 port valve to investigate why occasionally the boiler does not get a call to heat the water and noticed that even if I tape the...

Can I interchange the head with another make, don't want to drain down to replace... I've already replaced the motor on this valve so I think it's time to change. I can get Honeywell, Drayton, Siemens... Thanks..

I noticed that the Torbeck valve farts when shutting off. It's quite loud. I do not have any pressure regulator in the valve because its fed by the tank in the loft ( 2 storey house). Anyone know what causes it .. TIA

Hi I'm replacing the toilet cistern valve which is well past it use by date with a Torbeck Ecofil bottom entry valve.. The new Torbeck connector is shorter than the original by 5mm so i need to do a small amount of plumbing work to re-connect the cold feed. The pipe size is 15mm so i thought...

I need to cut a 110mm soil pipe and re-connect using a flexible connector. Toolstation sell 100mm and 150mm flexible connectors http://www.toolstation.com/documents/search/index.html?searchstr=flexible+connector&submit=Go I'm confused about sizing. Would the 100mm work for me. I have...

I currently have 2 toilets, 1 down and 1 upstairs. They are connected together into a common drainage system downstairs. The drain pipe run for downstairs is internal until it is above the upstairs toilet then it goes through the wall to vent to outside. There are no other vents in the run...

Yesterday I heard a humming noise which became quite loud. I discovered that the soil pipe was vibrating. This vibration could be felt by touching the stack. Also the toilet seats were doing the same. After a toilet flush it went away, diminishing slowly to a low hum and then no noise at...

Condensation from inaccessible joint... I have a water leak running down my internal soil stack which is coming from a joint that is 1 metre above the highest wet entry point. The joint seal is broken and during these cold months condensation is forming higher in the pipe and escaping out...

Hi, I have a closed CH system, with an expansion tank. Boiler is a Suprima 60, expansion tank is a red bulbous thing with a pressure relief valve on top that has a gauge that red lines at 3.0bar. Earlier today I noticed pressure was shown as .60 on a luke warm system that was just starting...

The black plastic screw is loose and as you can see there's a bit of corrosion. Should I replace it. If so what do I ask for... Thanks....

I have had this boiler now for about 7 yrs and it has not been a good experience. 1st problem was the heating engineer, who installed the non return valve on the wrong side of the expansion bottle, so the pressure build on heating up had no where to expand to, so caused a few leaks in...

Help please.... I have a pressurised CH & HW system with an expansion tank (Boiler is Potterton Suprima 60), both are in the loft. PS I had problems with the Suprima locking out 2 years ago and fixed it by re-soldering all the joints on the PCB. It has been working ok to now.. My...