Search results

  1. K

    Jigsaw for fence post

    I have a new fence post i need to install. its 100mmX100mmX2140mm i need to cut some V shapes out of it to hold the horizontal supports. i have a Jigsaw from an old project and thinking i can use that instead of making a wonky mess of a hand saw. Looking online i get the impression the 10CM...
  2. K

    Ideal Icos Constant Flashing Burner Light

    I wonder if someone can help me. I have an issue with my boiler where with the C boiler status and the burner light flashing and then igniting. The problem since is that the burner stays on only for about a minute or less and the burner light continuously flashes all the time, after a while...
  3. K

    Sentinel Combiguard cartridge

    I need to replace my Sentinel Combiguard cartridge but ive not done it before. it obviously connected to the central heating system but i'm warried that during the phyiscal replacement at somepoint i need to unscrew it; wont water just start pooring out of the pipe work until i screw the...
  4. K

    Zanussi double oven keeps blowing the element

    I have a zanussi double oven which every 6 months or so keeps blowing the element. All of a sudden the trip switch goes and the over will then not be able to heat the over. I buy a new element and all is ok for 6 months. When i look at the element it appears that the rings have fused...
  5. K

    program 2000 integrated door

    Hi all, I have recently bought a second hand Program 2000 fully integrated dishwasher. I got the old door off but looking at the parts i can see how to put the door for our kitchen on. i have added two link below which are the parts used to fit it but if anyone knows or perhaps can point me...
  6. K

    Thermostat clicks off and on incorrectly

    Hi there, i have a Sunvic TLX 9201 fitted by the builders when i bought my house 3 years ago. Its always been a pain. I have a digital temperature gauge and when i place it on the thermostat i notice that if i set the thermo to 21 degrees it would switch off when the hall was only 16 degrees...
  7. K

    i need to keep bleeding my rads

    Hi all, very first post here so please bear with me. The presure in my central heating system keeps rising and i keep bleeding the rads to reduce it. I get in down to 1 bar when cold and then by a few weeks in back up at 2.5-3 bar. What could be doing this. Is water leaking into the...
Back
Top