Search results

Hi all I have a Rinnai water heater that requires a service, is this an appliance that most plumbing & heating engineers would carry out or do I need to seek out someone that specialises in them. I've read in the manual that a service kit needs to be purchased as part of the service. Thanks...

Hi I've notice that from within the attic space the under felt circa 1980 has deteriorated and needs replacing, the roof is tiled with Redland 49s, it is a two story house up and over approx. 50m2 of tiled roof area so what price would I be looking at for scaffold front & rear, strip off tiles...

Hi Looking at fitting a gas water heater for hot water supply ( 3 bedroom house ) kitchen & bathroom plus one shower, currently have the Johnson & Starly warm air system for room heating which we are happy with, the Janus 3 water boiler is dated and fails to deliver constant hot water hence the...

Hi I'm hoping someone can help me with this, 18 months ago brought the cannon dual fuel cooker, works fine however on occasions when cleaning or over boiling water gets between the hob plate and the burner pots then comes into contact with the ignition electrics then bang off goes all the power...

Hi Looking for ideas or a solution to my shower winter problem, we have a three bedroom house fitted with a gas warm air system with the Janus water boiler attached so the shower is electric which is okay in the summer but in winter when mains water is freezing the pressure of the out flowing...

Hi Can anyone help me with this, we brought a cannon cooker July 2016 and every now and again when water boils over onto the hob plate it seeps between the gas burner pots and the hob plate as there does not appear to be water tight seal, this allows water to come into contact the ignition...

Hi I'm hoping the answer is straight forward so here goes, we have the dreaded johnson&starley warm air system circa 1980s and in fairness works fine. The thermostat is mounted in the front room it's the original Honeywell wired in type, we plan to redecorate and would like to change the...

Hi Does anyone know if wheels can be fitted to the front of a Bush tall fridge, it has rollers on the back but nothing at the front. We need to move it out from its current position as it blocks the water draw on the tumble dryer so a set of four wheels would make it easy to do this. I'm...

Hi all, My daughter has just moved into a three bed house circa 1900 that has a consumer unit fitted, her issue is when she switches on the tumble dryer the main switch on the CU trips out but some ceiling lights remain on, she then resets the main switch turns on the tumble dryer and all works...

We have fitted a J&S warm air system with the Janus 3 water heater alongside both working OK what I would like to know is the current hot water cylinder ( indirect ) is 950 x 450 can I upgrade it to a 1050mm cylinder to give a greater amount of hot water for a larger bath now fitted. Of course...

Hi Our kitchen floor currently has ceramic tiles over Weyroc floor boarding, I'm aware that a ply board 4mm - 6mm is used traditionally for the tiles to be bedded on using a flexible adhesive but I was wondering if any tilers had used metallic lathing with a gout filler to form a more uniform...

hi, need some help we have fitted a 900 x 450 indirect cylinder in airing cupboard fed from a cold water tank in the loft, this cylinder only supplies hot water to bathroom and kitchen tap it was connected to the gas warm air Janus 3 water heater but was disconnected by previous owner so now the...

Hello and help required please On my daughters C5 the drivers internal door handle assembly has come off, any ideas what the screw fixings are that release the lining to get to the inner door skin? I know on older cars it use to be phillips screws but i think thats all changed now. Many...

Hello to all I need to know the best way to tackle over painting two bedroom ceilings both of which have been painted before using a silk paint. I wish to over paint using a matt finish but need a base coat first, any ideas please. Geoffm1066