Search results

Why should temporary continuity bonding clamps be used if cutting in to a copper water/central heating or gas pipe. Is it something to do with if the pipe is live you would become the pipes path to earth?

Has anyone used this. I seem to have got some ridiculously low quotes one offered. £100 to swap a toilet and basin for vanity unit and concleaded. Then swap radiator for towel radiator would involve draining down the system.

Can anyone give me some advice on balancing a central heating system. How many turns up should the rads be you knock down. Thank you

I need to add inhibitor to a system after a drain down. There is 13 rads. On the system and a small section of underfloor heating serving one room and a hall way. How much sentialx100 would I need. Thank you

I have a rad to change position in a room and fit a new rad. All the other rads in the house are pipes flow to the top of rad. Return to the bottom It's a sealed system combi boiler. Would there be any benefit of piping fitting the new rad the same. Have never done it like that before. Is it so...

Can you connect 10mm speedfit elbows on to 10mm copper?

Would anyone have an idea why this boss 110v drill may have stopped working. I have taken apart to see if was a loose connection but can't notice any thing. I have had a volt stick near it and it picking up power all the way through. Thanks for any help

Does anyone else struggle to get a good Finnish with cheap silicones? I usually use dow conning or forever white. But have tried a cheaper one and struggled to get a good Finnish.

Do they do a washing machine tap that will take two appliances without putting one of those V connectors on a single tap. Thanks

Are the telescopic version of this better as you can lower the handle below the bath possibly?

Are the riser kits for shower trays with the threaded bar that screws in to the tray any good?

Is working for the councils as a plumber good? There is a few perks big holidays sick pay etc

Has anyone used the 10mm plastic paneling?

Hi does anyone know if you can still get this flush valve? I know it's ideal standard thanks. I'm hoping to get the same.one so it with twist out of the Carrier. Otherwise I will have to take the toilet out. Thanks.

I have a leak on a bar shower mixer valve. To unscrew and replace the washer do I need to hold back on the 3/4 thread somehow?

Anyone fit filling loop Isos. For isolation and dcv on outside taps?

What could be causing this. It isn't a sludge problem as the system has been flushed. Thanks

For how long after a tap is run. I.e pressure drop in the system. Should this valve fill for after each use? Thanks

Is it ok to fit a magnetic filter on a y plan open vented system. On the return pipe around 2 meters from the boiler. But with no returns teed in after the filter. Thanks

How much water should this let out each time a tap is opened? I turned it down as was filling the cistern fully after the basin tap was opened once.