Search results

Hi my toilet has started overflowing for about 10secs after flushing, it then stops. I have an arkadia inlet valve (i think) not a ball float or syphon. I removed the cover and top arm and checked the rubber seal that covers a small hole on the top, this was worn. I flipped this over to...

Is there any simple test that i can do to determine if it is one or the other? What is an APS?

With CH off. When I turn the hot tap on, the boiler flashes up for 15secs, then off for 15sec and repeats this cycle with a constant flow.

The water from my hot tap runs hot and cold i have descaled the heat exchanger but it is still doing this. Flow rate is fine. I have an Ideal combi CF85 (something like that) boiler.

My radiator has sprung a leak from the side near the top. Not near any valves just on the side, it's about the size of a pin point. Is there anything that i can fill the hole with. I would buy a new one but i cant find one the same size 450mm X 24500mm. Any help on either front would be great

The Combi boiler is an Ideal CF65 or 75 I think. Don't know how old it is at least about 4 years Shower mixer is this one. http://www.screwfix.com/app/sfd/cat/pro.jsp?ts=35889&id=19454 I'm sure its connected the right way round as red goes hot blue goes cold. Hard to check actual pipes...

I have a combi boiler and have just installed a new shower. The mixer says it is OK for combi boilers but when I use the shower it runs hot and cold. My water pressure is good. No other appliances or taps were being used while showering. :?:

The problem was that my filter had got blocked by stew! and had overflowed into the motor compartment = one new motor needed :oops:

The extended cycle light on my Ariston LI62 flashes and does not wash. No water seems to pump in, the tap is on and there is no kink in the pipe. Help :?