Search results

Livng in a bungalow theres little head of water to the kitchen sink, so purchased a Salamander pump to boost the hot water to tap. Worked perfectly for 6 months but now the only way to get it to kick in is to wave a strong permanent magnet on the end of a wand near the end of the unit. Now, what...

I would like some advice on insulating my kitchen floor please. I have ceramic tiles laid on a sound and dry 50mm screed, but during the winter the room is always cold. I'm quite prepared to lift the screed to accommodate an insulation material, but there are pipes crossing the floor buried in...

Hi, I want to stop my bathroom door opening on its own accord. I thought there was a problem with the door frame being out of plumb, but cannot find evidence of this being the case. Of course if closed all the way it latches and stays there but it always swings back towards the wall if not. I...

Getting fed up with replacing batteries in my kitchen clock. Does anyone know of any device or kit to get it to run off the mains ? The battery is AA 1.5 volt. I have lots of ex phone chargers but would need to know how to bring the volts down.

What is the correct way to install an outside rcd socket ? 1). Connect to ring main, but when test button is pressed it takes out whole of the house because both main and socket are 30ma rated. 2) Replace main RCD in consumer unit with a higher rated tripping current. 3) Use an...

Why are there no reducing couplings on the market to accommodate the old sized round 65mm to 68mm downpipe. And vice-versa ? Plenty of square -round jobbies but surely you don't have to replace every fitting. We're talking plastic here guys.

Hi guys I plan to render a piece of frost damaged outside wall. What mix would be best and what materials ? Do I make good the flaked off fronts of some of the damaged bricks with ordinary sand & cement first ? Thanks Kbultray

I have two sets of cupboard doors in the house. Both are of hollow construction and in both cases the Right hand door won't shut because they're slightly warped. I've been looking for a strong catch to hold it in place, but so far drawn a blank. Ideally I would like one of those closers where...

Hi guys. Could you tell me what is state of the art method of renewing tatty edges on roofing felt where it's supposed to overlap in to the gutters,installed in the 60s please ?

We have a garden wall which is facing a window and it looks terrible.Frost has taken its toll and fetched the faces of about a third of the bricks.Not only that,there's salt covering it as well.What we want to know is how can we improve the look of the wall now.What options please ?

My property has an incoming main supply but the cut out has no earth terminal. Whom do I approach to get one fitted ? My neighbours who are on the same supply network have one on their cut out. Is it the company who supplies the fuel or a separate concern ?

We have a small portable gas heater which works fine. The flame is blue and it gives off a good heat but this winter when it's in use there's a smell like the old Calor gas heaters used to give off. Any ideas please? Regards MC

Is it possible to purchase singles (double insulated) cable now, or is it no longer manufactured or permitted for that matter? Thanks KB