Search results

How much stored hot water would be needed to feed two kitchen sinks and two wash hand basins?

I usually try and run the waste under the plyth. If this isn't possible is it ok to run higher up behind the unit. I think there is usually a 75mm void? Would then require the joiner to knotch the back of the units.

What is the unit called that the ground source heating pipes go to to transfer the heat from the refrigerant to the heating pipes to go around the system? Thanks

Would you swap bath tap cartridges on a bath tap were the bath panel is all tiled in? I'm just thinking of something went wrong can't get to them.

If fitting a vanity basin like this. Would it need the basin bolted to wall or just siliconed to the top of vanity and wall. The unit will be screwed to the wall

If fitting a vanity and concealed cistern in a cloak room. Is it best to Lino/laminate under the units. I.e fit first or fit the units and the the flooring after? Thanks

What is the best way to cap speed fit pipes? Speedfit push fit caps or compression?

Is this flexible hose going to blow imminently? I saw it today

How much lower are scrap copper prices in January? Thanks

Do anyone know any where that sells offset fill valves like this

I have a tap that has black bits coming out of the cold side of the kitchen tap. If it was the washer breaking down the tap would drip? Any ideas what it maybe?

I need to cap some central heating pipes in a boxing. What is best solder if can get rid of all the water? Speedfit or compression? Thanks

When balancing rads. Mainly the upstairs to throw more heat downstairs. How far down should you throttle the locksheilds. Is a quarter of a turn open enough? Thanks

Is there anything different I need to do when draining a central heating system that has underfloor heating on one side downstairs? Also for refilling thanks

How would you tile a kitchen with sockets like that, that are so close together? Thanks

If you mount pipework on the surface of a plasterboard wall. Would it still be possible to use angled rad valves. Copper pipe run horizontal then and elbow straight in to the angled rad valve. Is there another space for the copper pipe before the fitting?

Are colum radiators easy to hang. How are they usually bracketed?

Is it ok to put hep2o street elbows in to compression fittings. With a copper olive. Thanks

If tiling a kitchen of the worktop. Do you usually tile straight on to it. Or put a spacer between it. Thanks

I spoke to someone about tiling a kitchen they said they have put something around the sockets for safety until it is tiled. Any idea what this is?