Search results

Hi Guys, My heating pump is still run long after the heating and hot water have gone off If I switch off the mains to the whole system and back on, its back to normal and stops Is this an overrun issue ? Frost Thermo / 3 way valve / Drayton programmer ? Any ideas ? Thanks for replies in...

I have some damaged soffit, see attached photo - which I believe is Cement fiber board ? - but it's extra large 6ft x 2ft - maybe 3 or 4mm thick Any Ideas where I can source this in the West Midlands ? Many Thanks in advance for all replies

Guys, I'm a little confused - the lifestyle wiring center has a room thermostat as terminals 2 ( call ) and 3 ( com ) I've wired terminals 1 and 3 on a danfoss RET230P to simply join these terminals together to kick the heating in - but it's not working Have I missed something / is it...

I have a Lifestyle Wiring Centre MK1 for my central heating and a Salus thermostat ( volt free contacts ) across terminals 2 and 3 to switch on heating. I need to have another thermostat upstairs in the house, can I simply connect another thermostat with volt free contacts in to connections 2...

Right, after much bashing all my old quarry tiles are up including the adhesive and the kitchen floor has only minor imperfections Question is do I need to seal the floor before laying porcelain tiles with Keraflex Maxi ?

My Worcester 15/19 is dead , the water jacket has rusted through in multiple places :( So the question is go for another worcester or something different ? Any recommended suppliers ?

Hi Guys, I have a Worcester / Danesmoor non-condensing 15/19 oil boiler. Over a period of two days the pressure drops from 1.5 to 0 bar The leak is under the boiler, all entry pipes and PRV are dry making me think it's a heat exchanger problem - look at prices they are £ 600 ish ( ouch ! )...

I have a Danesmoor 15/19 oil fired boiler - the central heating works OK but I've noticed that the pressure reading drops from 1.5 bar to .25 bar following the heating being on for some time - on further inspection I have water on the floor in the garage around the boiler I suspect either the...

I have recently removed a pantry in my kitchen and now have three redundant cables - light switch, light socket and a 13a outlet cable hanging from the ceiling Without ripping down the ceiling or pulling up the upstair floor can I simply terminate the cables with a choc block and push back...

Well my old plastic tank ( 2500l ) was slowing sinking in to the ground so I'm mid way through re-doing the base.. The current tank is single skin ( not bunded ) so I'm thinking it's time to replace it ( 12 years Old ) Jesus , new ones are expensive at around £ 875 for a 1200-1400 litre...

Hi Guys, I have an atlas 2500l tank I need to move , rebed the foundations and put back. It's nearly empty so almost ready to go The plastic coated oil pipe that connects to the tank appears to be just pushed on , which I doubt .... is it usually swagged on ? Thanks in advance for...

I have a closed loop central heating system , usually pressurized to about 1.5 bar When I go away next month could I drain the hot and cold water tank and leave the heating ' ON ' with no issues ? I expect it would cause no problem as it's closed loop ?

Hi All I have a Triton Caselona II that has worked for over a year no problems - but now have no water output... The mains light is lit on the pull cord The neon is lit when the shower is 'off ' When switched to ' on' the neon goes out No water output via showerhead or via PRD...

I have a glowworm F which will not ignite unless the ' reset ' ( RED button under the boiler ) is held in for 10 seconds or so - I presume this is the thermal cutout button ...? The pilot is on so no issues there.. Once running it's not a problem - but obviously I can't time the heating to...

Can someone offer advice I need to span two columns with a lintel that will support 3 rows of bricks ( or lightweight blocks There is no need to support anything on top as there is a concrete lintel in the second skin of the wall - it's simply to finish off the square arch I'm creating...

Guys, I have a Halstead Finest combi boiler ( god knows how they came up with that name ) CH is OK, no problems but DHW fails - switch on tap , banging noise in the boiler , boiler cuts out after a few seconds - water runs cold ... So, is this the DHW ( plate ) heat exchanger or the...