Search results

I have a double up and over garage door powered by a Hormann motor. When operated the door will open by a few inches and then stop. On other (rare) occasions the door will fully open without stopping. Could this intermittent issue be a problem with the sensor detecting a non existent...

I have a double up and over garage door powered by a Hormann motor. When operated the door will open by a few inches and then stop. On other (rare) occasions the door will fully open without stopping. Could this intermittent issue be a problem with the sensor detecting a non existent...

I have several large brass items –mainly exterior door fittings etc- which regularly need cleaning. I can achieve a good finish with brass polish but inevitably after a year or so they begin to dull and tarnish. Of late I’ve used OOOO grade steel wool resulting in a good shine (no polish) but...

I need to fix a plate to concrete paving slabs using M6x50mm concrete bolts/screws. I've read differing views some saying a 5mm pilot hole others saying 6mm. What size bit should I use? Thanks

Hi Folks I’m buying a small 12v DC motor which is required to rotate in both directions.Some of these motors are sold as ‘reversible’ whilst others don’t mention this in the description. Aren’t all of these motors reversible if the polarity is swapped? Thanks Roy

We are laying a patio partially within the RPA of a TPO tree (upon application the LA didn’t want to know!) In compliance with Arboricultural Practice Note 12 (APN12) and BS5837 the layers are as follows, starting from the ground up: Ground Geo textile membrane Geocell (or similar) cellular root...

I would have been best posting in the Gas Fitters Only forum but I'm not a RGI so here goes. We wish to have installed either a Bells vento classic or a Gazco Riva2 750HL Edge -virtually identical gas fires. The Bells vento classic requires a balanced flue or possibly a chimney flue. However...

We have a shower in the ensuite bathroom fed from a hot water tank in the airing cupboard via a pump in the loft. We recently had the family bathroom refitted and a new shower installed with the feed T’ed off the existing pump outlet. When the new shower lever is turned on it can take several...

I’m having a conservatory built, internal floor 18 sq m. The builder will finish at the screeded floor level and I will install the flooring. I will be laying electric underfloor heating mats and I’m undecided between tiles and laminate flooring. Some of the conservatory companies advise...

In a previous post under ‘building’ I have raised various questions relating to foundations for a conservatory. Due to clay soil conditions and a nearby mature tree two separate structural engineering companies have advised me to have a hole dug as close as possible to the existing house...

I have obtained five quotes for a conservatory at the rear of the house. There is a mature oak tree (with a TPO) in the garden approximately 8 m from the proposed rear wall/foundations of the conservatory. Three companies have allowed for 1m foundations saying this will be adequate and two...

I'm after some very small wire/leads to connect up to a PP3 9v battery, same size as shown here. http://www.maplin.co.uk/Module.aspx?ModuleNo=44392 I can't order any without knowing the size of wire - any advice appreciated.