Search results

I want to install 2 dahua POE cameras in fairly remote locations and wiring is a problem to these locations except they currently have mains 240v. don't want to use wifi etc so powerline adaptors which also provide POE would be ideal such as these...

my felt roof has small leak which is allowing water to leak through onto inside of the roof (see picture). its next to the vent pipe for the tumble dryer and on the top this area of about 50cm x 50 cm has been sealed previously (probably when the vent pipe was installed 20 years ago) with a...

hoping to fit plastic wall cladding in the bathroom on top of the old tiles. the tiles are firm but I've read that the surface of the tiles must be sanded to provide a key - how precisely do i do this? just sandpaper and elbow grease? also, the tiles go right down to the floor boards where the...

So the system is a Potterton Profile 80e and its over heat cut out was tripping daily. Its never had anti corrosion stuff in it so based on advice from this forum decided to work through the potential causes in the following order: 1) drain system 2) replace pump 3) put in some DS40 4) refill...

fitting a new plastic cold water tank in the loft to replace the 40 year old metal one which sits above the hot water cylinder. the path that the pipes will run from the new tank to the current connections on the old one are tricky and difficult & will require numerous corner joints etc. any...

hi, i've searched and cant find a similar problem to mine so hope someone can shed some light. the fan runs as normal and after the typical amount of time (about 10 seconds) the gas valve opens but there is no ignition. i know the gas valve opens as the boiler is close to the gas meter...

Hi Guys, Hope you can help. Potterton Profile 80e. Just returned from holiday and the boiler keeps tripping the overheat cutout. Turned the heating off for the first time in 2-3 years so it doesn’t get cold under normal usage. It runs for about 1 minute then the overheat trip operates...