Search results

Gas engineer opened boiler front (Worcester Bosch Greenstar 25i combi) condensation dripping from boiler casing roof inside and down the front of the casing on the inside. That much sweating/condensation that it runs out over the controls and drips from the two housing screws on the bottom of...

Just had the annual boiler service and the engineers report has come from the cover company stating we need to have remedial work completed to prevent any potential claims in the future being declined on our policy. Remedial work required: double anaconda on the meter. I presume this means the...

System log:- 205) SET PRGRAM 21:35:57 206) ENTRY START 13:11:46 Zone 1 207) ENTRY TIMEOUT 13:12:15 Zone 1 208) INTRUDER 13:12:51 Zone 1 209) INTRUDER 13:13:05 Zone 1 210) INTRUDER 13:13:07 Zone 1 211) INTRUDER 13:14:21 Zone 1 212) INTRUDER 13:14:27 Zone 1 213) INTRUDER 13:14:34 Zone 1 214)...

I have a sealed magnetic contact connected to the Accenta Gen4 on my wooden shed door, I replaced it with a sealed metal contact on previous advice near 2 years ago. Previously I used the standard white plastic contacts and even tried a heavy duty contact for a gap that is always near enough...

Firstly in short: If anyone knows of a door contact that doesn't require magnets, a mechanical held down switch perhaps please let me know. Thanks. :D After my last thread about the contacts requiring regular replacement on my outbuilding due to false alarms, I tried as suggested the heavy duty...

I have a 1000L water tank (IBC Container) that collects rainwater for the garden. It was raised about 50cm from the ground on a wooden frame that is now collapsing. Basically, I'm wondering if those lightweight aerated concrete blocks would take the weight and be okay for this outdoor setup...

I have a new dual fuel cooker coming next week and I paid the extra £80 to have it connected by a gas safe installer when it is delivered. (littlewood's catalog) The gas pipe hardly sticks out of the wall and has one of those 1/2 flange plugs on it. All the installer says is they will only...

Magnetic Contacts. Plain white, standard surface mount, cater for four wires, but only use two just for trigger. One set on one building, other on different system in another building. After 3 years with no alarms, get false alarms "door", happens again, then again. No wind, no door...

I've got a wired Accenta Gen4 setup and would like to add a sounder or audible alert speaker 30 metres (open air) away in the main residence. To notify me the alarm is sounding in that building, even with the loudest of bell boxes it can sometimes not be heard with fans etc going. :| Any...

Can additional strobes be added to my system or will this interfere with the bell box strobe? I've got the Accenta/Optima Gen4 with a Lynteck/Midas Bell Box and I've added a standalone strobe and connected it to the +/- strobe terminals in the control panel. However the bell box is...

I've got the Accenta Gen 4 with LCD keypad, I had a Reson8 Bell box connected for the past 3 years that suddenly started to smoke on a routine test. I'm looking at a new Bell Box, and as its for a small building I would like to replace the reson8 with the Lynteck LY65-016-57 midas low profile...