Search results

Hello, We are in the process of moving, again. The new property is in need of complete refurb and we are adding a new 2 storey extension. I am thinking about the appropriate design of the CH and DHW. There are a few requirements that I would like to include: - All zones independently...

Hello, I have a 33 odd m2 rendering job to be completed. Looking for a coloured (off white) finish. The board is on, scaffold up and it's ready to go. Two quotes in so far from five asked for... £65 ~ m2 £100 ~ m2 A bit of a difference, and to be honest on the high side I think. What is...

Hello, We have a thermal store in our house that heats the mains pressure hot water via a heat exchanger. This is great for current use which is one bathroom with a shower and bath. The only downside being that if someone else turns on a tap when you are in the shower you lose all the...

Hello, My 2.5 year old Intergas Compact Combi 36 has decided to no light this morning. Error code 4 is showing and displays again is I do a power cycle. The manual says to call my installer, I am going to do that but thought I would post here first to see if anyone has any ideas...

Hello, I have a 175 litre water butt which is filled primarily by a rain water diverter. This works a treat, empty to full in three hours of rain last night. Whilst we live in a rather wet country I do at some stage in the summer hope that I will be using it more than the rain can fill...

Hello, We have had a lovely warm floor bathroom for the six months. On Saturday the floor did not heat up. It's a Devimat 3.5 m2 - Timber (350 Watt Capacity) purchased from Tile Fix Direct wired up to a Heatmiser Touchscreen Control PRT-ETS. I have tested the resistance of mat and...

Hello, I have an issue with the temperature of the water from the shower. It warm, verging on hot but not quite as hot as I would like it. I will say at this point that it is perfectly usable. It's just that when I come in from a long cycle in the wet and/or cold it's a few degrees under...

Quick question... I think my plumber has installed the TF1 on the wrong pipe! It's currently on the CH Flow. Should it not be on the CH Return? Or does it not matter. Regards, Simpic

Hi, We are planning on converting the ground floor of the house to UFH when we do an extension. I am also looking at running six pipes from the boiler / motorised valve / UFH manifold area to the garage (part integral) for the future installation of a Heat Store. These pipes will need...

Hi, I'm looking for some help to verify the proposed schematic I have attached. The context is replacing an open vented system in a 60's / 70's house with a combi and UFH. Looking at a Intergas Combi. Also, if someone could point out how to add a zone for a towel radiator as well...