Search results

  1. S

    Biasi combi - no hot water

    The heating works fine and when the heating is on the hot water is fine too. But when the heating is off there is no hot water. I was told it might be the diaphram part number BI1011103 "Central heating pressure switch membrane" which I replaced but it made no difference. So, here's what...
  2. S

    combi boiler - pressure gauge too high and overflowing

    I have an Ideal c24 mini combi, approx 8 years old, that is leaking hot water from the overlow (pressure relief valve) pipe outside - I estimate approx 1 lite per minute. The pressure on the guage was reading maximum at 3.5-4 bar so I assumed somebody must have opened the filling loop too much...
  3. S

    Combi boiler Ideal C28 Mini - no hot water or heating!!!

    I hope someone can help. The boiler had been drained (was empty property for 6 months) and I have filled it up to 1.5 bar. When I try to run in Heating Mode the boiler goes through its motions for approx 20 seconds (I can't see any ignition taking place) and then stops and the green light...
  4. S

    Biasi M90e 32s Boiler - no ignition spark

    Boiler is apprx 3 year old and has stopped working, i.e. not getting any hot water or heating - pls help! The boiler tries to start-up, i.e. the pump appears to run as I have checked by removing the middle screw and the shaft is spinning, however, the fan does not run and there is no spark on...
  5. S

    Lincrusta wallpaper

    Anyone out there with experience of hanging Lincrusta wallpaper? Have just bought 2 rolls of Adam frieze and the special adhesive but am not sure how to go about this. I want to hang it above the picture rail in my kitchen to give it that authentic victorian look. Is it just the normal case of...
  6. S

    Wiring for a Fridge

    After reading some topice her I am convinced that I need a seperate circuit for the fridge. I have a split load, 5RCD + 5 non-RCD. I have a spare 16A MCB on the non-RCD side so I think I can run a cable from here to the fridge. The question, is it ok to use 1.5mm T&E and that this can be radial...
  7. S

    Gas Bayonet Connector

    Any CORGIs out there? At the risk of incurring some wrath from you I'd like a bit of advise please.... I'm wanting to connect one of those Wall Plate Elbow things onto a 15mm copper pipe and then screw a Bayonet fitting into the elbow ready for a Cooker Pipe. A mate of mine has told me that he...
  8. S

    What's the maximum number of downlights/bulbs

    A bit of advise please... I'm wanting to install lots of downlights and wall lights (Mains mainly, but a few low voltage) in the house and I'd like to know if there is a limit so that that I don't go over board. If my MCB has 6A rating and 1.00mm T&E is used for the lighting circuit what is the...
Back
Top