Search results

  1. L

    C24 Timber Shakes

    I've got a workshop on the go and unfortunately didnt check the timber that arrived at the time as I should have done! It's for my workshop and so not overly worried about the shakes and imperfections as they dont go all the way through. I just wanted other chippies opinions, is this typical of...
  2. L

    Structural Engineer recommendation Please

    Can anyone recommend a structural engineer please, I have a small (4m deep x 5.5M wide) extension where i want to expose upto the rafters and also a calc for a wall being removed (if its load bearing) Ive been quoted 375 plus VAT which sounds alot and obviously want more than one quote to see...
  3. L

    Extension pitched roof

    Hi all, we are planning on adding a pitched roof to an extension we want to build with Marley concrete tiles on it and two roof lights in it. The total span will be about 5.5 metres. 31 degrees pitch. Which leaves the rafters length at 3430mm and the rise 1646mm What I wanted to ask is if we...
  4. L

    Texecom Elite 48 - Smartcom not connect to Cloud

    After the recent firmware upgrade, I now have a problem connecting the Smartcom back up again. Ive tried all sorts: the guidence is to disable Arc1 protocol - reset Smartcom pressing reset 5 times until the lights flash, then keeping my finger on the reset until the WIFI light starts to flash...
  5. L

    Flash Upgrading Texecom Elite 48

    Despite following what it says in the PDF ie power down the panel - disconnect all from the comm ports When flashing via the port (pin1 in the right orientation) it failed to flash and the panel deadish - The power was applied once the USB Jac001 was in place and set to prog. with no power on...
  6. L

    Texecom Premier Elite 48-W

    Anyone know how to recover one with access to the ports? I've flashed mine to V.3.00 thinking I had removed the Com-IP module from Com1 ops! and it failed the flash, tech support said it should be ok but im getting the same "board not responding" error when trying to connect to it via the...
  7. L

    Ideal logic boiler - heatmiser TM1-TS timeclock RTS1 Stat

    Hi all I have the above combination effectively replacing the timeclock i have. Im trying to find out how to wire the 3 together they are using 2 core plus earth at the moment. Heatmiser told me: L from the time clock to L on RTS1 L linked to 'C' terminal Call for heat (switched live...
Back
Top