Search results

Would a Flexi installed like this before ok. Would be for a concealed cistern. Or would that be classed as going up hill?

I have this concealed cistern 500mm it's tight too tight for a soldered bent tap connector are end feed ones tighter? Or any other ideas? Thanks

I have this tap leaking slowing constantly from the tap body. Does it need a new cartridge? I'm guessing it's the oring on the cartridge that has gone?

Would it be ok to tile over this surface? After all the old are removed?

I was looking at some taps. It says in the document with it max pressure 3 bar. Do most taps suggest this? As most people will have more unless a pressure reducer is fit or there in a unvented hot water heater with the feeds balanced down to 3 bar after the composite valve on the feed to the...

Is it ok to use he2o fittings on speedfit pipe?

I have this pressure reducing valve leaking from where the black plastic bit screws in to the brass housing. Is a new prv the best fix here? Thanks

The tail on taps have a bevel now that will take the seal of an olive. Does anyone pipe taps up with copper pipe and a nut and olive. Instead of a no.62 tap connector or Flexi?

Is it ok to pipes these up with flexis with an iso valve?

If putting plastic pipe in a wall chase. Is it not advisable to solid plaster over any fittings?

What could be making an immersion heater trip when turned on at the switched fuse spur? It immediately trips on the main board. Thanks

I am swapping some rads and altering pipework on a system. A couple of rads I am leaving unfilled(Off on the valves). So the decorator can remove to paint. Would the system be ok without inhibitor in after I refill for say 4 days? I could then add the inhibitor when I put the rads back on after...

Has any one worked for British gas, octupus etc installing heat pumps? Just wondering what the job is like.

Hi does anyone have an idea what maybe wrong with a concealed cistern toilet that constantly runs in to the pan. The customer says they can stop it but keeps happening. Thanks

Usually the tiles give good enough fixings for a shower screen. But what if the shower is panelled with the plastic panelling? That is hollow in sections.

Is this damage repairable on a stone resin tray?

Is this a worn guide causing this?

If glueing overflow pipe would you glue the pipe only. Or both the pipe and fittings? Thanks

Will this be a problem long term?

I need to produce a power point on this matter I was thinking of including stuff like crimped pipe, and hydrogen blend on the gas side. Any more ideas please?