Search results

Currently fitting a new kitchen Current cooker setup is a 6mm T&E from Board (B32 breaker) to cooker isolation switch then direct to the cooker Our new kitchen has 2 single ovens in the design Is it right to say I can buy a dual cooker connection plate and connect both ovens to this circuit They...

hi need to connect a nest heat link to my Worcester Bosch Greenstar 30si 2008 I am only interested in the heating not water so should be 3 cables Can someone just confirm my thoughts of where I connect too Diagrams below Many thanks

hi Planning on removing a conservatory and replacing with a single storey extension pitch roof, looking at the picture below can anyone see a problem leaving the existing soil pipe in position (manhole is in the garage ) Boiler flue is the biggest problem I can see Also planning on getting to...

Above is what I have apologise for being side on I'm now thinking its not good to screw plasterboard to frame as for future access I'm thinking I will hang the sheet on 45 angle back to back blocks so will slot down in and hang Would you keep the 9.5mm plasterboard to tile on or change...

I know it's been asked a million times before but what would people fit in a kitchen these days My last house we had 12v ones Are the Jcc led ones as good Everyone raves how much cheaper they are to run but is the light as good

Is it normal to have 2 different size cables on your meter to isolation switch and then to consumer unit ? See below

Hi moved into a new house On the consumer unit shower and immersion have been crossed out (they have been removed) The breakers are now used for a cooker and hob The cables are 2.5mm and wired as a ring for both The cooker is 3.0kw and has a 20a breaker The hob is 6.5kw and has a 30a...

Deleted

Hi just bought a property the only bonding is from consumer unit to cold water pipe Is this ok or does gas meter need doing ?

Currently my boiler is powered by a fused spur from a single socket I want to remove the single socket as a it's too near sink and b is in condu and looks a mess I have enough cable to position the fused spur above the boiler flue directly in middle of boiler by shortening the current drop to...

Hi i really need help/ advice from someone i have 2 sets of decking lights installed on my deck (2 lots of 10) and ive woken up this morning and our new puppy has eaten through the cables going in to the plug in transformer! i have literally 1 inch of cable left on each what are my options...