Search results

Hi my father has a problem with his heating witch is now my problem its a open vented oil system this is the problem currently the boiler fires on ok and heats but then cuts off upstairs where the tank and pump are all the pipes are cold the pump is noisey and when you turn the screw no...

hello, if my hot water flows at a rate of 8 litres per min and i have a mains cold water flow which should be good. what bar pressure mixer shower should i be going for to maximize the flow???don't want to buy something like a 10 bar rate if i don't have that rate and i don't want to buy 5 bar...

hello, i decided to fit out my en-suite in my bedroom all the plumbing was in place with pipes appearing a few inches from the ground. where the shower would go there is one pipe, from that i assumed that the pipe would be mains supply for a electric shower because only one pipe but when i...

Hi,i'm about to tile a shower i have 3 walls 2 of which are plastered brick walls one will plasterboard on batons which will be screwed and stuck to a brick wall! would something like thompsons waterseal do for tanking plasterboard and plaster surfaces before tiling??? fionn...

hi, a fuse on my consumer unit keeps blowing it's a 5 amp for the oil heating. it started to happen after i installed a new light fitting on my bathroom ceiling with a additional light as well.the old ceiling rose had lots of wires going into it,i drew a diagram of this and disconnected the...