Search results

Hi all, Just moved into a new property with attached garage. Garage has main up & over door. Lock made by "Horrman", need to replace cylinder but don't have the key .. also same goes for the Door into the garage. No keys for euro lock on that Either. Door to garage has euro cylinder, but its...

Hi all, I have the above Tumble dryer... The model im not sure of at the moment but will check tonight. Recently, the element stopped working. I replaced the element with an Indesit one from one of the local shops that deal with Washer repairs etc. To replace element its remove the back...

Hi all, Just a quick one, do you have to use Texecom Keyfobs ? Or will any brand work (but with issues) ? I ask as someone I know is installing an alarm (Tex 48 with prox) and has Castle Care keyfobs that are new but unused. Will they work ? Thanks

Hi have discovered a few errors today after firing up my alarm, RKP 1,3 Tamper and Faulty Detector (stairs). Also I keep getting the message on screen "Engineer working on site". I can reset and then I get my banner screen but cant arm/part arm. Any ideas ? Thanks in advance all.

Hi all, question for you... id like some advice on best practice / or any advice. I want to arm my back gate (door contacts), however its a good 40 - 50 meters away from the back of my house, then another 15 meters or so to my alarm panel... what would be the best way ? My idea was to run 4...

Good Afternoon This is probably dead simple but I'm putting in a door contact (Reed witch) on my front entrance. I have 4 core cable from it to my RKP. I can see how to wire up the door contact side... however where abouts do I connect the Door Contact inside the RKP is it on Area 1 /2 ? (Im...

Hi all, Looking at getting the above and installing it... Never done anything like that before regarding this product. How is it setup ? is it wired to a zone on the panel ? how is it setup ? is it always armed/set ? Any information greatly appreciated! Thanks

Hi all, is it possible to wire my door contacts into a PIR than going into a keypad. I have an issue where by I want to add door sensors to my patio doors but I cant get cabling from back door to RKP but there is a PIR close to the doors (facing them in fact). So is it possible to connect the...

Hi all, Im setting up the above system, I'm currently awaiting the arrival of the external bell box which should be here next week. Ive got all door contacts, PIRs and RKPs in place. My question is... can I run the system without the bell box for now ? When it arrives I can shutdown and...

I have the above DVR, I've forgotten the 'Admin' Password. Have the manual and tried the default for admin, but to no avail. Wondered if anyone has any ideas on how to reset the password. I have Access to the motherboard and have removed battery etc. Thanks in advance Kind regards.

Hi all, I have the above titled Dishwasher... it was already in the house when we moved in and was in decent nick, have thoroughly cleaned it out and it's working fine, only issue is and I can't see how to fix it... The right hand side of the door seems to not be closed properly and steam...