Search results

I have a fully wired Texecom system that is about 7 years old. Over the past couple of months, the alarm has sounded twice for zone 001, the front door contact. The magnet is mounted within the door frame so it's all hidden and cable runs inside the wall, it is wired EOL. When the alarm sounds...

Hi I have a Vaillant Exclusive 832, which feeds 7 radiators in my bungalow. I have an issue with radiators making like a whistling noise when the heating comes on in that room (I use EvoHome so only one or two rads are normally on at one time). When the boiler was installed, it was not...

Hi Hopefully I have put this in the right place. I have a retaining wall down the side of my property about 6ft high. The wall was rendered this summer as it was bare before and looked terrible. After it had all dried etc, we painted it white with Sandtex. The retaining wall had a closeboard...

I have one of the above panels that has been running for about 3 years. I came home the other day to see an error on the RKP 'Mains power off'. Checked and everything was okay, so cleared the error. It was only a few hours before it popped up the error again. Tested the mains, all okay...

Hi I have a new shed in which I want to install a door magnet. I have run 8 core cable underground from the shed back to the control panel. From there, I have joined two wires (orange and orange/white) to two spare cables going to RKP 2 (blue and yellow). In RKP 2 I have connected blue and...

Hi I have just built a new shed and wish to add it to my Elite 24 system. I have all 8 zones used so I will have to add to one of the free zones on one of the keypads. I assume the best sensor would be to have door contacts as a PIR will surely just get false alarms with spiders etc? Also, I...

Hi I have an issue, I am completely out of ideas and am pulling my hair out! I have the ComIP module that has been installed. Everything works okay, it polls to Texecom and the iPhone app works very well with notifications etc. The issue is that it keeps producing an error about Com1. I then...

This system is brand new and has been installed for about a month now, no issues. The ComIP module works perfectly, all the PIRs and keypads etc. The only issue I cant resolve is the SMS feature on the Com2400. I have tried all the TAP providers I can find, I even signed up to OpenTAP. When I...