Search results

  1. G

    Replacing light fitting

    Hello, I am trying to replaced a ceiling light pendant with a LED lamp fitting. Existing bulb holder has two wires, blue and brown that connects to the ceiling fitting but the new lamp fitting has an earth fitting too. I am just not sure where and if I need to connect the earth on new fitting...
  2. G

    Replace Fluorescent tube with LED tube

    Hello, My fluorescent light stopped working, so decided to replace the entire fitting with a LAP LED batten. Two issues that I am hoping I can get help with. 1. I removed the wires from ceiling to the existing batten and now it looks like the image below. Am I right in saying, all I need to do...
  3. G

    Replacing Salus RXWBC605 with Tado Wireless

    Hello, I have a Salus RXWBC605 receiver connected to my Worcester Greenstar 37CDI combi boiler with ST621RX controller/thermostat. Bought a Tado wireless thermostat (and smart valves) to replace Salus. I was hoping it to be a easy diy task of removing old unit and reconnecting new unit, but I...
  4. G

    Wardrobe exposed back wall - Add back panel

    Hi, We have built-in wardrobe with no back panel so the wall is exposed. It is an outside wall so considerable amount of dampness and mould forming at the top inside wardrobes. To avoid cold air in the wardrobe and also to look better, I am considering the following options. 1. Cover the...
  5. G

    Garage conversion - Heating

    Hi folks, I am converting my detached garage in to a living space with insulation (walls, floor and ceiling). Primary use is for my office and a gym. Dilemma with the heating, wife says simple electric convection heaters as we will not be spending lot of time in this space. I was hoping to...
  6. G

    Drilled incorrect size holes

    Hello, Sorry this may be a very dumb question :unsure: Trying to attach a retractable garden hose to the external wall, instruction said drill a hole with 10mm bit which I did but the plastic anchor goes in the hole too easily so the bolts are not screwing in. Now, would it be wise to ignore...
  7. G

    Veritas 8 Alarm problems

    Hi, I had to change the battery on the Veritas 8 alarm. While I removed the panel, tamper light lit and started beeping. Entering my code silenced it. I then turned the mains off before touching the battery as cables were all over the place. Replaced the battery and the alarm went off, entering...
Back
Top