Search results

It’s Important that all manuals comply with industry standards

I also think you need to up your game dan , are your manuals up to date .

Yes quality component the omega however the adey filter also has a slip socket to. Good price was that with vat ?

I used to have a supervisor much the same , I used to fix his c0ck ups regularly. He loved manuals more then his wife I think !

persistent silly trolling

persistent silly trolling

persistent silly trolling

persistent silly trolling

Locking the valve over is a temporary solution to give you some hot water , the controls need to be electrically fault finded and replaced accordingly by a tecnitian not a bathroom fitter Have you locked the valve over yet and done what I have adviced ?

You will either need a new programmer or cylinder stat , this was obviously about an hour ago to us , call a local heating guy or link your programmer , turn off your heating fused spur , remove what will like be 2 screws underneath the programmer, remove from the back plate and link terminals L...

So for now do what I said please , lock your valve over , turn on your heating on makes no odds if your water is turned on or not, turn your boiler temp down to 60 degrees and report back

This proves that either your programmer or cylinder stat are faulty

What we are trying to establish is whether your hot water controls are operating correctly as they influence the valves movement depending on demand in relation to central heating requirements

Now then stat up on tank to 90 and does the lever drop back to mid way ?

This will allow the boiler to circulate around your cylinder , turn the programmer and room stat up to 30 , on the 3 port valve slowly push over the leave when it reaches its end you should be able to latch the level into a little cut out slot to keep the valve open , you will then hear the...

To get you some water assuming no immersion heater fitted, push over the leaver and latch it into its catch , turn on your heating and turn your rads off If heating not required, turn your boiler stat to 60 degrees to avoid scalding domestic hot water

If after linking out the programmer then your cylinder stat will need replacing

What’s funny dan ? I agree with the above poster, a lot of your engineers on here don’t look at things with any logic you just read your manuals

Ha ha ! Gigglepin I can’t take you seriously I need to know to know if your a red or blue gigglepin ?

So what’s the point in this forum lol